Please see the link below There is a section on seatbelt laws on the web page
Yes. The only autos not coverd under the seat belt laws are the ones built so long ago that they were not installed at the factory. yes you need seat belts in the jeep however Because of the year of your vehicle you are only required to have what would have normally been installed by the factory in 1973 which would have been the front seat and rear seat single Lap belts. The 3 point shoulder belts that are used today were not required in US vehicles until Feb 1974 so there were many pre 1974 model vehicles with just lap belts and no shoulder belts...
Yes, it is advisable to use seat belts even in older cars that did not originally come with them, as they significantly enhance safety during a crash. Many jurisdictions have laws requiring seat belts in all vehicles, regardless of their age. Retrofitting a vehicle with seat belts can help protect passengers and reduce the risk of injury. Always check local regulations and consider the safety benefits.
Depends on which car and which belts.
I have the belts used. Do you need the size? harleycr@nwi.net
these days the waist band is made with a material for keeping the garter up and no need for belts
Probably due to slipping when they get wet. Your belts might need to be changed.
Depending on how many miles are on your vehicle. If you have 35k or more you need to replace your serpentine belt or all of your accessory belts. And if you have 89k or more you need to replace your serpentine or accessory belts and your timing belt.
If the vehicle came equipped from the factory with belts it has to have them.
Are they new belts or old belts. If the belts are new they may need to be tightned or a belt tensioner may need to be replaced. If all are new and tight there may be a part that is failing and is sliping cause it very hard for the belts to trun it.
Yes, stronger seat belts would be necessary for a rocket due to the extreme forces experienced during launch and re-entry. Rockets undergo intense acceleration and deceleration, making it crucial to secure astronauts effectively to prevent injury. Standard seat belts used in vehicles would not provide the necessary support and safety under these conditions. Additionally, the design would need to account for potential vibrations and impacts during flight.
The main professions which need tool belts would be the engineering professions which adds up to four tool belts skills to engineer's arsenal based on the equipped utility and heal skills.
You do not need seat belts if your car was originally manufactured without them, and they have never been installed. At any time seat belts are installed, they must be maintained for the lift of the car.