yes its much easier to change.make sure you jack engine before
there is an Allen screw and a nut on the throttle cable you loosen the nut and the screw and adjust it to make it idle up or down.
The harmonic balancer on a 1990 Toyota 4 Runner is turned clockwise to loosen it. This is backwards from most bolts to prevent it from being loosened by the rotation of the engine.
Gas engine is counter clockwise to loosen. Diesel engine is clockwise to loosen.
loosen the one or two bolts holding the alternator in place, i believe 14mm, then loosen the 12mm on the adjuster (side) and "screw" the 12mm bolt down to lower the alternator down enough and replace the belt. This is almost the same for every Toyota engine which doesnt use an automatic belt tensioner (serpentine) on the alternator.
To remove a radiator from a 1997 Toyota Tacoma the truck needs to be cooled down. The coolant needs to be drained, and loosen the radiator mounts. When everything is loosen remove the radiator.
loosen the bolt on the tension pulley. then insert a 3/8 ratchet in the square hole on the pulley that will loosen the belt
Loosen the distributor and rotate it.
This means you have a 4.0L. There is no other way.....
The air filer on a Toyota Tacoma is located in the engine compartment of the vehicle. Find all the bolts holding the air box down and loosen them. Remove the plastic housing to reveal the air filter. Replace the air filter.
Turn the nut on the rear storage box to loosen the nut
disconnect the battery source first, disconnect the wiring on the alternator, then loosen the bolts on the mounts to loosen the belt. then loosen and remove the bolts. remove the alternator, and replace with new one.
The serpentine belt on a 2003 Toyota Rav4 can be loosened by turning the retaining bolt on the idler pulley. The belt can then be shifted inward to loosen.