0
What else can I help you with?
How do you change a flywheel on a 1991 Toyota Tercel?
Pull the motor out of the car and change it.
Can a 1991 z28 v8 beat a 1999 v6 firebird in 8th and quarter mile?
Maybe what motor in the z28? 5.0 or 5.7 ? either way u should have to torque to pull ahead of the v6
Do you have to pull the motor in a 91 Pontiac firebird to get the oil pan off?
No you do not , But it's one hell of a job to get off.
How do you remove blower motor on 89 firebird?
To remove the blower motor from an '89 Firebird, first disconnect the negative battery cable for safety. Next, remove the blower motor cover by unscrewing it, then disconnect the electrical connector from the blower motor. Finally, unscrew the blower motor from its housing and carefully pull it out. Reverse the process to install the new motor.
Do you have to pull motor of 350 Chevy to change rear freeze plugs?
Pull the motor or pull the transmission, one of them has to come out.
How do you change spark plug wires in a 1989 Pontiac Firebird?
pull one off at a time to change them dont get them mixed up
If the fuel pump on your 1991 firebird is disconnected can you pull fuel through it with another fuel pump?
yes i have a 91 bird and its working that way
On a 1990 dodge Dakota to change the left and right motor mount can the motor be lifted to change the motor mounts or do you have to pull the motor out?
It can be done by lifting the engine up.
How do you change blower motor 1991 Toyota pick up?
it is located under the glove box under the air duct unplug the wire remove the three screws pull out motor and install new one reverse sequence
Do you have to pull motor to change the clutch slave cylinder?
Yes
1991 Nissan 240SX transmission removal?
take out the halfshafts pull the motor and unbolt the tranny
How do you remove the windshield wiper motor on a 1988 Firebird?
To remove the windshield wiper motor on a 1988 Firebird, start by disconnecting the negative battery cable to ensure safety. Next, remove the wiper arms by unscrewing the retaining nuts and pulling them off the splines. Then, access the motor by removing the interior panel or cowl cover, followed by disconnecting the electrical connector and unscrewing the motor from its mounting bracket. Finally, carefully pull the motor out of its housing.
