0
Do you have to pull to pull the motor to change rear crank seal 1994saturn sc?
Wiki User
∙ 12y ago
yes. because it is front wheel drive, you also have to remove the transmission
Wiki User
∙ 12y ago
Add your answer:
Earn +20 pts
Location of crank sensor on 2.0 Geo Tracker?
The crank sensor on the 2.0 DOHC engine is behind the flywheel (flex plate) on the back of the motor. In order to change it you must pull the transmission or motor.
Where is the crankshaft tone wheel on a 4.7 Jeep Grand Cherokee located?
on the crank near the back of th motor you will have to pull the crank out of the motor inorder to change the wheel i have a 2000 gc and just had to do this it is not an easy task
What should you do if you have spun a bearing in your motor?
you have a couple options, you can pull the motor and have it rebuilt swap in a used motor from a junk yard drop the transmission and pull the crank, replacing it with a new crank rods and bearings if you are lucky you may not have scored the crank and you can replace the one bearing ang rod or you can junk/sell the car
Do you have to pull motor of 350 Chevy to change rear freeze plugs?
Pull the motor or pull the transmission, one of them has to come out.
How do you pull a crank shaft off?
You don't pull it off. You pull it out. If you are lucky, you can do it with the motor in. Pull the oil pan, and main bearing caps,etc...(long answer) not easy for the home mechanic.
How do unlock a hydro locked motor?
Pull the spark plugs and crank the motor over and over. be sure to have an other car there to jump it if you run out of juice.
How do you find the crank sensor on a 1996 Chevy Monte Carlo?
depends on the motor 3.4 has two one is behind the crank pull and the other is on th back of the block
How do you change a flywheel on a 1991 Toyota Tercel?
Pull the motor out of the car and change it.
On a 1990 dodge Dakota to change the left and right motor mount can the motor be lifted to change the motor mounts or do you have to pull the motor out?
It can be done by lifting the engine up.
Do you have to pull motor to change the clutch slave cylinder?
Yes
Where is oil pump on 7.3 ford diesel?
Simple enough. pull the harmonice balancer, aka the crank pulley. remove the crank seal and there is the low pressure motor oil pump for the 7.3
How do you change 1993 Corvette crank pulley?
take off the belt, use a pulley puller to pull it then reinstall.
