Want this question answered?
YOU NEED T TAKE OUT TRIM ON TOP OF RADIATOR AND HAVE LONG FINGERS TO REMOVE OR U CAMN TAKE BUMPER COVER OF AND REMOVE HEADLIGHT TO GET IT
You have to unbolt the entire soft bumper and remove. The dealer did this on my car to replace the headlight assembly.
yes
you have to remove the screws from the top of your bumper and remove the screws from the front of the wheel well bumper should slide forward then remove two bolts on top of headlight then remove bolt under headlight then housing should come right out
First, you'll need to remove the front bumper. To do this, take off the bolts underneath the front part of the bumper. Remove the bumper turn signals to access the two bolts per side that hold the bumper on the car. Support the bumper by putting something underneath it. Then get a stubby Phillips screwdriver and remove the two screws per side at the end of the bumper (in the wheel well). Bumper should come off. Remove the headlight assembly by diconnecting the headlight sockets, remove the 10mm bolts above each headlight assembly. Remove the 10mm bolts below the headlight assembly. Done.
Open the hood, take off the bumper (the placement consists of a few clips) and you have access to the headlight bolts. Unscrew those and you will remove the headlight.
No, you do not need to remove the bumper. here is a video on how to change your headlight really easy. http://youtube.com/watch?v=ieXVCTWQHSY I did it just to see how easy it was and it was pretty easy.
# Remove the front bumper cover # Remove the upper headlight housing mounting bolt and pushpin # Remove the lower headlight housing mounting bolts # Pull out the headlight housing assembly and disconnect the electrical connector
To replace the AC clutch discharge the freon, remove the clips, and remove the screws under the bumper. Remove the driver side headlight, and bolts.
You must remove the front bumper to access the headlight.
there is 3 10 or llmm nuts on the back of the headlight assembly, then once that is removed there will be 4 torx screws that hold the headlight trim in place, once these are removed then bumper fillers can be installed.
Remove the wiring harness from the back of your headlight assembly. Remove the headlight assembly retaining bolts. Reverse the process to install your new headlight assembly.