answersLogoWhite

0


Best Answer
Copy

The instrument cluster can be removed by removing your headlight and hazard switches then the panels under the steering wheel. You have to ultimately remove the plastic housing that the switches are in. In order to gain access to those screws you will have to take the lower panels off and work your way up to the housing

User Avatar

Wiki User

โˆ™ 2005-05-12 21:52:47
This answer is:
๐Ÿ™
0
๐Ÿคจ
0
๐Ÿ˜ฎ
0
๐Ÿ˜‚
0
User Avatar

Add your answer:

Earn +5 pts
Q: Do you have to take the dash apart to replace the speedometer on a 1991 Mustang?
Write your answer...
Submit

Related Questions

Where can you buy a 1991 Ford Mustang 160mph speedometer?

Wal-Mart


How do you repair the speedometer on a 1991 Mustang?

It is an electric speedo so it can be the speed sensor or in the speedo itself.


How do you check or replace a speedometer in a 93 Ford Escort wagon?

Look up 1991 ford escorts manual transmission speedometer


How do you replace the speedometer cable for a 1991 Geo Prizm?

The 1991 Geo speedometer cable is held in place with a swivel nut on each end of the cable. Turn the swivel nut to the left to remove the speedometer cable. Reverse the process to install the new speedometer cable.


Is the 1991 Nissan Sentra speedometer cable drive or electronic?

The speedometer is cable driven.


Where is the speedometer sensor in a 1991 Plymouth voyager and how do i replace it?

It is in the axle shaft housing on the right side of the transmission. It is held in with one 10mm headed bolt.


Speedometer bounces on 1991 dodge dynasty?

A 1991 dodge dynasty speedometer bouncing could be a sticking speedometer cable, or a bad drive gear. Check the cable first, and lubricate it to see if the problem stops.


Will a 1990 mustang hatchback suspension interchange with 1991 convertible mustang?

yes it will


What is the gear ratio for 1991 Ford Mustang 5.0?

I had a 1991 Ford Mustang 5.0 L - LX - automatic , and it had 2.73 's


Horsepower for 1991 5.0 liter Mustang?

In a 1991 Ford Mustang : The 5.0 liter V8 is rated at ( 225 horsepower from the factory )


How much does a 1991 Ford Mustang cobra cost?

There is no such thing as a 1991 Mustang Cobra, SVT did not start producing the Cobra until 1993.


Where is a IAT sensor at on a 1991 mustang gt 5.0?

where is the intake air charge temp. sensor on a 1991 ford 5.0 coupe mustang


Will the transmission from a 2000 Ford Mustang fit a 1991 Ford Mustang?

hellz no, but who can stop the from trying?


Does a 1991 Ford Mustang gt have a timing belt?

No , the 5.0 liter High Output V8 engine in a 1991 Ford Mustang GT has a timing CHAIN


Will a convertible top frame off a 1991 mustang gt fit a 1987 mustang gt?

No 1991-93 Mustangs use a different frame for the top.


What if any are body parts are interchangeable between a 1991 mustang and a 1991 cougar?

There are absolutely no body parts that interchange with a 1991 mustang and 1991 cougar. The mustang is a fox body chassis and the cougar is on the mn12 chassis. The older cougars I believe pre 1988 were structurally similar to a mustang, by this i mean engine bays very similar and rear ends interchangeable. As far as the bodies they did not have interchangeable parts.


Your 1991 Chevy Corsica speedometer went out now when it cuts in the car wants to die can they be linked?

The speedometer is controlled by the speed sensor and it also sends signals to the transmission on when to shift so your problems could be related. The speed sensor is easy to replace and is located on the transmission.


Will the front seats from a 1989 mustang V6 fit a 1991 mustang gt?

Yes the front seats from a 89 mustang v6 will fit in a 91 mustang, the tracks are the same.


1991 Ford relay starter?

I need how to wire relay for 1991 ford mustang.


What will happen to your 1991 for explorer if you exceed the maximum speed on the speedometer?

nothing


Where is the OBDII port located in a 1991 Ford Mustang 2.3L convertible?

The 1991 Ford Mustang does not have an OBDII port, because OBDII was not standardized in the United States until 1996.


Where can you find a Fuse box diagram for a 1991 Ford Mustang?

Try: www.veryuseful.com/mustang/tech/engine#Diagrams


Will the front seats from a 1988 mustang gt fit into a 1991 mustang gt?

Yes they will bolt down with no modifications


Will a 302 1991 mustang engine fit into a 1973 mustang?

yes, the 5.0 (302) will fit in a 73' for sure.


What the spark plug gap of a 5.0 mustang?

On my ( 1991 ) Ford Mustang 5.0 liter the spark plug gap was ( .054 inch ) What year of Ford Mustang ?