0
Yes. The crank sensor tells the coil when to fire.
Wiki User
∙ 12y ago
Add your answer:
Earn +20 pts
What does a code PO725 mean on a 2000 dodge stratus?
speed sensor malfunction. you need to check the trans codes
Where is the crank sensor located on a 1996 Dodge Ram van 3.9 b2500 and how do you install a new one?
The crank sensor is located on the bell housing of the transmission on passenger side. You will need an Allen wrench.
Where is the crank shaft sensor on 99 dodge cummins?
It is on the drivers side buried behind the starter. You need to remove the starter and then you have access to it.
Do you need to replace cam sensor after replacing the crank sensor?
if you have a code w/ cam to crank reference then yes. if only a crank sensor issue the no
Why wont your 93 dodge stealth start turns over no start and it does not have a crank cencor do you need this?
If the 93 Stealth came with a crank sensor but it does not have one now, then it will not start. The sensor shows the ignition coil when to send power to the spark plugs.
Crank sensor location 84 Chevy 2.0?
They did not use a crank sensor in 1984, There was no need for 1
What type of oil does a 2001 dodge stratus need?
5w30
No compression after replacing timing belt on 1996 dodge stratus?
It's out of time. You need to make sure the crank and cam gears are in alignment before installing the belt. If the belt was broke, the valves could be bent.
Where is the crank sensor located on a 1995 Oldsmobile Aurora 4.0?
The 1995 Oldsmobile Aurora 4.0 liter engine crank sensor is located on the back of the crank. You will need to remove the rear engine cover in order to view the crank sensor.
How to change a fuse for brake light on 2000 dodge stratus?
You need to SWAP THEM!
Where is the fuel pump on a 2000 Dodge Stratus?
yhe fuel pump in a 2000 dodge stratus is under the fuel tank. in order to change it u will need to take down the tank.
Where is the location of the Crank Sensor on a 3.1 Corsica Engine?
The Chevrolet Corsica 3.1 liter engine crank sensor can be found on the back of the engine. You will need to remove the rear engine cover in order to access the crank sensor.
