0
Do you need any special tools to change the brakes on a 2000 Grand Prix GTP?
Wiki User
∙ 16y ago
For a list of tools and step by step insructions check out the following website. http://www.oqcgp.com/forum/kb.php?mode=article&k=14 Hope this helps. "G" The quick answer is no. I recently changed my brakes on my 2000 GTP and it does not require any special tools.
Wiki User
∙ 16y ago
Add your answer:
Earn +20 pts
What tools do you use to change the brakes on a 2003 Pontiac grand prix?
what tools do i use to change the front brakes in my 2003 Pontiac grand prix
Do you need any special tools to change the front brakes of a 2000 Silverado Z71?
No special tools needed.
Is a special tool required to change the brakes on a 350z?
nope just standard air tools
Are there any special tools required to change the rear brakes in a 2009 Dodge Journey?
Yes, a special tool is required to compress the caliper pistion.
How do you change the brakes on a 1999 Chevy Silverado?
more infoAre you talking about front or back? The front pads are easy to change. The rear may require a little more work and some special tools. what kind of special tools
How do you replace the rear brakes and are special tools needed for a 1997 Mercury Villager?
The brakes on the Villager are as straight forward as the brakes on a 1965 Mercury. Only normal brake tools are required.
Do I need special tools to replace brakes on 2005 Sedona?
Basic hand tools should be enough.
What kind and size tools do you use to change a starter in a 1987 grand marquis?
Common mechanic's handtools. No special tool is needed.
How do you change the front brakes and the back brakes on a 1999 Alero Oldsmobile?
First of all, Do you have any specialty brake tools? Ben
What tools are needed to change the brakes on a 2000 Chevy silverado LT?
a torx bit size t-55 for front brakes
Are there special tools required to change the fuel pump in a 99 montaro sport?
No, no special tools needed, just common hand tools.
I never changed brakes how do you change rear brakes on a 2000 gmc truck?
Drums are not a job for beginners. With the right tools & a manual you could do it.
