Potentially, Yes.
The "EML" warning light in a BMW indicates a problem with the "drive by wire" throttle control system."
Drive by wire" throttles use a computer controlled stepper motor rather than a purely mechanical linkage (usu. metal cable attached directly to the accelerator pedal) to control the opening and closing of the throttle plate.
A flashing or solid "EML" light does not explicitly mean the throttle body is bad, but this can be the case as the throttle has many heavily used moving parts (both mechanical and electrical) with great potential to wear out and fail. The "EML" system is quite complex and service typically requires a factory trained (or exceptionally skilled mechanical & electrical) technician, with access to sophistocated diagnostic tools.
The "EML" system plays a major role in the control of the engine. An "EML" light will often be accompanied by very noticable vehicle driveability issues. Stalling, stumbling, low idle, extremely rough idle, and/or a lack of throttle response are all very common.
Depending on the year of the vehicle, a problem with the "EML" system can be difficult to diagnose, and very expensive to repair. If the throttle is determined to be the problem, it is possible a disassembly and cleaning of the throttle motor, motor brushes and sensors can help, but this is something one would have to do on their own.
Owners of earlier BMW cars may opt to retro-fit a standard mechanical linkage (cable, throttle, pedal) to their cars, but this can also be very difficult/expensive and will elminate some of the features the "EML" system provides (traction control, cruise control).
How do you replace a throttle body on a trailblazer 2002
Is it easy to replace a throttle body in an 88 sentra? How do you clean a throttle body
If it is similar to the 2002, and I believe they are, It is permanently attached to the throttle body. To replace the sensor, you have to replace the whole throttle body.
It is a part of the throttle body. You have to replace the throttle body if faulty.
how to replace fuel injector throttle body in a 1988 nissan pathfinder 3.
You will need to remove the throttle body and replace the throttle body gasket. The throttle body gasket can be purchased at most auto-parts stores.
On the side of the throttle body opposite where the throttle cable connects. In other words the side of the throttle body facing the fire wall. You will probably have to remove the throttle body itself to replace the sensor as the screws that hold it to the throttle body are vary difficult to loosen.
Lubricate or replace control cables Replace throttle body
You can not change just the TPS for this car. You have to replace the entire throttle body.
There is not speedometer cable on a 1996 Honda Civic. There is a throttle cable. Top replace this unhook it from the throttle body and gas pedal. Hook on the new cable to snake it through the firewall. Properly hook the throttle cable to the gas pedal and throttle body.
Check the throttle body over carefully to find the leak. If a gasket is leaking then a new gasket set will stop the leak. If the body has a crack then you will need to replace the throttle body.
i need to replace a throttle sensor and put a throttle body rebuild kit in