Is it easy to replace a throttle body in an 88 sentra? How do you clean a throttle body
If it is similar to the 2002, and I believe they are, It is permanently attached to the throttle body. To replace the sensor, you have to replace the whole throttle body.
You can not change just the TPS for this car. You have to replace the entire throttle body.
There are two injectors at the top of the throttle body. If you can see that one works and the other does not, then replace the nonworking injector
A fuel injector pulse is the product of an electrical charge controlled by the ecm to briefly open an injector. If the engine is throttle body injected, you would find the injectors in the throttle body.
you must remove the throttle body, remove the seal and harness grommet, then the injector cover. then with the throttle valve held open tap the injector with a hollow bar being careful not to damage it. remove o rings and disconnect from wiring harness.. when reinstalling remember to coat the new o rings with silicone
1 injector
Pouring the injector cleaner down the throttle body won't clean the injectors. You need to add the injector cleaner to the fuel tank for it to help you. Read the instructions on the container of injector cleaner.
How do you replace a throttle body on a trailblazer 2002
Gas pouring out of the throttle body would probably be caused by a leaking injector seal.
In the throttle body, no but each fuel injector (there is two of them) has a filter.
If your referring to a fuel injector. Follow the air intake tube in to the engine and it will run right into the throttle body on the norm.