It does not matter on the rods. When torquing the main caps you need to start in the center and snug all the bolts down alittle bit at a time moving from center cap to the next one beside it towards the rear of the engine a then the other one beside it towards the front of the engine moving back and fourth until all the main cap bolts are snugged down. Then TORQUE them all down the same way you did the first time. Just remember to rotate the crankshaft every time you tighten a rod cap bolt are a main cap bolt to make sure nothing locks the engine up/ stops it from rotating.
Torque settings for main bearings and big end bearings
The Caterpillar C15 diesel engine torque specifications for the rod bearings is 35 pounds. The main bearing torque specifications is 350 pounds.
What are the torque specs for the rod and main bearings for a1999 isuzu rodeo 2.2. engine
Specs for main bearings on a 2003 Chevy trailblazer with 4.2 engine .
you can find it at autozone.com
27NM plus 90 deg
Rod bearings - Step 1 - Torque 15 ft. lbs; Step 2 - Turn 75 Degrees Mail bearings - Step - 1 Torque 37 ft. lbs; Step 2 - Turn 77 Degrees
how to replace the rod bearings in a 1996 saturn 1.9 still in the car
70 ft lbs
what is the head bolt torque setting on daewoo matize
To what torque should the rod and main bearings of a 1977 366 GMC truck engine be tightened? The rods have 3/8" bolts and it has 4 bolt mains with 1/2" bolts.
big end bearinds 1st loose torque 45nm +90 Degree then do final torque 87nm.