after installing led lights my 08 Dodge 2500 the turn signal lights start flashing slow for 5 or 6 times then speed up to fast . the emergency flasers flash ok . hooking them up i used separate lights for the brakes , they are not hooked in with the turn signals
the tail light is screwed in from the inside of the bed of the truck
where can you find a website for free diagram of tail light wiring on a 1994 dodge 1500 truck?
on the tail light problem - unbolt the tail light from inside th truck -the hold tail light assemble will come out - it is recommended to change all the blubs your all ready there
tail lights circuit
The sport package, for a 1998 Dodge 1500 RAM pickup truck, will come standard with tail light covers. The covers have a chrome finish.
lower the tail gate on the truck. there will be 2 torqx head screws removed the screws it will loosen the inside of the tail light assy... pull on the tail light assy strait back. the light assy should come out turn the bulb casing on the back of the light assy and pull the bulb out.
Removing the rear lights on a 2004 Dodge Ram Laramie is a relatively straightforward process. Here are the steps you will need to follow to complete the job:Locate the two screws on either side of the tail light assembly. Use a screwdriver to remove the screws.Gently pull the tail light assembly away from the body of the truck.Disconnect the wiring harness and remove the tail light from the assembly.Install the replacement tail light and reconnect the wiring harness.Reattach the tail light assembly to the body of the truck using the screws.After completing these steps your 2004 Dodge Ram Laramie will have a new functioning rear light!
Have a look at this link: http://www.wikihow.com/Replace-a-Tail-Light-on-a-Dodge-Grand-Caravan
The tail light bulbs are accessible from underneath the back of the truck, up inside the rear of the pickup box.
where is dash light and tail light relay on 1984 nissan pickup truck
First, open the gate to the truck box. There will be 2 screws that need to be taken out for each tail light, located where the truck box gate latch catches the sides of the truck box on each side of the vehicle and about 5 inches below the latch connection. After removing the 4 screws, the tail light covers can be removed by gently pulling toward the back of the vehicle. The tail light covers are connected to the truck, so be careful not to break any connections or wires. When the tail lights covers are loose, twist to unlock each tail light housing from the tail light cover. Pull out the tail light from its socket, replace with a new bulb, lock the tail light housing and socket in to the tail light cover. Finally, put the tail light cover back into place and replace both of the screws which secure the tail light cover into its housing.
Probably a bad bulb They are double filamented with the smaller filament for stop and turn Larger is for tail light