answersLogoWhite

0


Best Answer
Copy

no, however the fuel pump has a secondary route through the oil pressure switch.If the fuel pump relay goes out the pump will run through the oil pressure switch after the engine gets oil pressure. this results in extended engine cranking time before the engine will start

User Avatar

Wiki User

โˆ™ 2015-07-15 20:03:17
This answer is:
๐Ÿ™
0
๐Ÿคจ
0
๐Ÿ˜ฎ
0
๐Ÿ˜‚
0
User Avatar

Add your answer:

Earn +5 pts
Q: Does a 1988 Chevy C10 with EFI have an oil pressure switch that shuts off the fuel pump if the oil pressure is low?
Write your answer...
Submit

Related Questions

Why would my 1988 Chevy Celebrity 4-cylinder run for a few miniutes then shuts down fuel pressure is good?

With good fuel pressure then I would check to see if it has spark after it shuts down.


How do you change the ignition switch in a 1988 Chevy Camaro?

How do i change the ignition switch in a 1988 Chevy camaro


How do you install key ingition switch 1988 Chevy S-10?

how do install key ignition switch 1988 Chevy s10


Does a 1988 Chevy pick up have a fuel safety switch?

That is called an Inertia switch and Chevy did not use them on there trucks.


What is the fuel pressure for a 1988 Chevy 5.3?

there were no 5.3 in production in 1988; but on a small block Chevy in 1988 you should have 22-25 psi


Does a 1988 Chevy pickup have a fuel pump safety switch?

NO. it does not.


What is the speed that the speed limiter on a 1988 Chevy Cavalier shuts off the engine?

between 130-140 ks


Where is the ac high pressure cutoff switch located at on a 1988 suzuki samurai?

it does not have a high pressure switch all it has is a evaporator temp sensor/switch.


Where is the relay switch on a 1988 Chevy Tahoe s10?

Which one? There are several.


Where is the Oil Pressure Sensor on a 1988 Chevy 1500 5.7?

The oil pressure sensor on a 1988 Chevy 1500 5.7 is located on the engine. It is on the right side, near the intake manifold.


1988 Mercedes E190 shuts off after 45 min driving?

It could be your overload relay switch!Try changing it.


What does the fuel pressure run on a 1988 Chevy Celebrity?

The fuel pressure should be 45 psi.


How do you make the pressure switch work on a 1988 coupe deville?

Fanks


Does a 1988 Chevy silverado 3500 have a fuel relay switch?

Relay, yes. Reset switch, no.Relay, yes. Reset switch, no.


Where is the power steering switch located?

were is the power steering pressure switch on a 1988 oldsmobile cutlass 2.8 engine


What is the problem when a car starts but shuts off when you release the key in the ignition switch if you keep the key turned a little it keeps running The car is a 1988 Ford Tempo?

Probably a bad key switch.


Where is he oil pressure switch on a 1988 Honda Accord?

trying rack down a leak


How do you replace ingintion in 1988 Chevy surburban?

cylinder? key? switch? fuse? module? what are you talking bout?


How do you remove and replace a power steering pressure switch on a 1988 Chevrolet Celebrity?

The power steering pressure switch screws in. Simply unplug the wire harness, unscrew the old switch and screw in the new switch. Plug the wiring harness back in.


Where is inertia switch on 1988 Chevy C3500?

Chevy trucks did not have a inertia switch. You need to check the fuel pump fuse and relay and then make sure you have power back to the fuel pump that's in the fuel tank.


Is there a fuse or switch you should turn off before removing a fuel filter for a 1988 Chevy celebrity?

The ignition switch should be in the locked position. The fuel line should be under pressure, wrap it with a towel so that when you loosen the connection it will not spray fuel everywhere, particularly on you.


Can you switch a motor from a 1994 Chevy astrovan to a 1988 Chevy Cheyenne?

You can as long as they are both 4.3l but you will need the intake and throttle body from the 88 as they are slightly different.


Where is oil pressure switch on 1988 celebrity?

The location of the oil pressure switch depends on which engine the car has. On the 2.8L V6 the oil pressure switch is on the side of the block below the exhaust manifold on the radiator side of the engine. On the 2.5L 4 cylinder engine the oil pressure switch is located on the side of the block below the intake manifold.


Where is the ignition switch module located on the 1988 Cherokee limited?

module locatedwhere is the module on a 9 Chevy blazer


How can you tell if a throttle position sensor goes bad on a 1988 Chevy 2.8 engine?

loping idle. does not maintain idle, sometimes shuts engine off. do an ohm test.