0
Want this question answered?
Be notified when an answer is posted
Add your answer:
Earn +20 pts
Where is the starter for a 1991 dodge stealth located?
The Starter for Dodge Stealth R/T's are located on the Front Right hand side of the car, it is actually attached to the front bottom of the Transmission next to the exhaust pipe and the front motor mount. It should have a Red rubber cover over the terminal as if it was a Battery. GSM
Where is the Roll Over Switch on a 94 Dodge Caravan?
Dodge doesn't use a roll over switch, The fuel system is controled by relays.
How big is the gas tank of a dodge stealth?
my 93 rt tt takes over 18 gallons sometimes at the pump when not empty
Why wont your 93 dodge stealth start turns over no start and it does not have a crank cencor do you need this?
If the 93 Stealth came with a crank sensor but it does not have one now, then it will not start. The sensor shows the ignition coil when to send power to the spark plugs.
What could be the problem with an over accelerated 1991 dodge stealth that sounds like it's missing but doesn't feel like it and has a knocking sound from the engine?
My 1992 twin turbo AWD had a similar problem and the cause was a rod bearing. I replaced the short block for $3000.00 labor and parts.
1991 dodge Dakota won't turn over there is battery power I replaced the clutch fuse twice but it seems to burn out faster than normal whats wrong?
Dead short to ground in the clutch safety switch?
1991 dodge spirit the car will not turn over no radio wipers turn signals when the key is turned the heater blower works but the idiot lights do not come on either replaced the ignitionwhat now?
replace the ignition switch
1991 dodge dynasty 3.3L V6 Starter clicks but wont turn engine over new starter new battery and new ignition switch installed. Thers no response from the engine when key is turned.?
Replace the starter motor
2005 Dodge Magnum stuck in park will start but will not move out of park?
Check your manual for an over- ride switch/my 06 Magnum is doing the same thing/the over ride switch works..
How do you engage 4 wheel drive on a Dodge Durango?
Start rolling and reach over to the dash switch and flip it to 4h.
Is a 1991 Dodge Stealth better than a 1987 Toyota Celica?
a dodge stealth is not in the same standing as a celica.A stealth will out perform a celica any day.drives better ect...A dodge stealth is a high performance sports car that was way ahead of its time.A DODGE STEALTH is the funnest car i have ever driven...over vette, supra ect I have drove them all.A STEALTH RT/TT AWD will blow out a vette,supra very easy. I own 2 stealths and a zo6 vette,the stealth will leave it in the dust....From the jam packed cockpit that has all the gagues you will ever need to a very powerful v6 twin turbo awd ,Suspension,Drivetrain, Electronics,Steering & Chassis,Interior,Body & Lighting,and just plain looks..... __________________________________________________________________ ^I tried to read that and believe and understand some of it, but i couldn't. So here's my take: It depends on what you're looking to do. You didn't mention if it was an RT, or just the base FWD version on the Stealth, and you didn't mention what trim level Celica. If you're going to compare base model to base model, i would say that the Celica is a more capable, reliable car. The Stealth weighs almost 1000lbs more than a Celica, and that isn't exactly condusive to performance. The Stealth is also a huge pain to work on, it's an extremely packed, cluttered engine bay. It gets worse gas mileage, build quality isn't as high as on the Celica.... the list goes on. If you're looking for end result in performance, the ultimate horsepower car... then you get the Stealth RT and spend the rest of your life dumping money into it, busting your knuckles trying to wrench on it, and even though your car may have eleventy million horsepower.... it still weighs WAY too much to ever feel "nimble." Neither is better than the other.
You are rebuilding your 91 dodge stealth sohc engine and you need to know the gap between the crank and the bearings it is now over 3000 of a mm whats the right gap?
.015 to.02 / check with plasta gage
