It did not have one from the factory. Someone else may have put one on it.
It for whatever you tow brakes some are hooked to the master cylinder and some are electric is there a lever on the box?if so it's electric
To install electric brakes, first remove the wheel. Then remove the dust cap, nut, and washer; this will be the place where you install the electric brakes.
If installed correctly, it will probably brake better.
There a number of possible reasons why rear Êdisc brakes are locking up on a 2000 blazer with new installed brake pads. This may be due to twist in the brake discs or low level of the brake fluid.Ê
If you have already checked the brake fluid levels, you'll have to replace the master cylinder.
Yes. Unless, of course, you don't plan on towing it. Or only towing it very short distances at very low speed. Then you can get along without it.
Well, First, where the wheel cylinders replaced?Second, Do you have any other fluid loss? Example: Rusted brake line or Brahe hoses? Get back to me, Ben
it is to control the brakes, it links the brakes with the battery to make a less spongy brake through the electric current.
You should see either a brake controller box under the dashboard, or a wiring harness under or through the back bumper for hooking power from the van to the trailer.
Do not let them get down to the rivets. On disc brakes they have a warning tab installed.
No
A disc brake kit is used to convert an older automobile's drum brakes to disc brakes. Your 2001 Gallant already has disc brakes. It would not require the disc conversion kit. When you begin to hear your brakes squeaking it is time to take your car to the repair shop for new brake pads.