howdo you change the front axel of a dodge Dakota 2000 4x4
If it's a good day and the planets are aligned you might get by with a hundred dollars at the local alignment shop. Well, it works on mine, anyway.
Every car needs an alignment at some point. Even more so if the car pulls to the right or left, or if the tires are worn on the edges. So to answer the question, yes.
the upper A-Arms can be adjusted to some degree, But it is suggested that you take your vehicle to a shop and have a front end alignment done by a qualified professional.
they are in front and after your cat
My van has bad tires at front and better ones at rear, should wheel alignment be performed with bad tires?
The Dodge Dakota pickup truck has CV joints on both front wheels. The pickup truck also has a driveshaft, as it is rear wheel drive.
The 2010 Dodge Dakota does come with standard airbags for both front and backseat passengers. I was unable to find specific information for other years.
1992 dodge dakotas do not have front coil springs, they have torsion bars instead.
the front are 6.5 and the back are 5.25
The 2002 Dodge Dakota takes 21" replacement windshield wiper blades on both sides front.
On the front of the throttle body.
Front driver side.
how do i find out if i have ABS on my front wheel bearing , on my 2000 dodge Dakota quad cab 2 wheel drive
Four wheel is preferred.
Wheel alignments require special equipment, but to do a rough alignment,(such as after replacing steering parts)to get you to the alignment shop, you can measure the back of the front tires at center, and the front of the front tire at center and ensure that the two measurements are the same.Then go straight to the shop. Driving with the alignment out wears tires and can result in loss of control.
Front 5x2, rear 5x7.
This will require special equipment so it will need to go to a service center like sears, meinecke muffler, the car dealership, or other shops that have the equipment.
replace front brake rotors and pads.
I think it is near front grill in front of radiator
No, that will mess with the front alignment angles,
you need a front end alignment
An alignment machine would be the best way.