answersLogoWhite

0


Best Answer

Scan tool will tell you nothing. Check everywhere for leaks, if nothing is apparent then it sounds like a problem in the master cylinder.

User Avatar

Wiki User

10y ago
This answer is:
User Avatar

Add your answer:

Earn +20 pts
Q: Does a 2003 ford focus have to be automatically bleed with a scan tool cause you just changed brake pads and roters and the brakes won't firm up and we bleed it 3 times and still won't build pressure?
Write your answer...
Submit
Still have questions?
magnify glass
imp
Related questions

After changing plugs and wire on a 1997 jeep wrangler what will make?

Price brakes most expensive brakes and roters for 1992 jeep wrangler


Do you need to change your brakes if you put 22 inch rims on your car?

you do not need to change your brakes, but the extra wait from the rims will burn up your brakes alot quicker. if u have the money it is best to put on some slotted roters


Roters and brake pads have been replaced a month ago on front of vehicle. Should brakes still be squealing when brakes are applied?

Depends on the kind of pads/rotors you got. It's normal for some compounds to squeak .


What cause the car to wobble when slowing?

you might want to check the brakes and roters they might be broken or warped...that would be the my first guess...then you might check the alignment


What does mean if you say you turn your brakes?

YOU CAN'T TURN YOUR BRAKES.BUT YOU CAN TURN YOUR ROTERS. JUST TAKE IT TO A SHOP IT SHOULD ONLT COST ABOUT 10 TO 20 DOLLORS A SIDE.


When did Ernst Roters die?

Ernst Roters died on August 25, 1961, in Berlin, East Germany.


How do you change roters on a 2002 GMC sierra?

You need to remove the brakes after this is done take a hammer and hit the rottor on the piece that is around the axel as you do this turn the rottor and it should come off.


When was Ernst Roters born?

Ernst Roters was born on July 6, 1892, in Oldenburg, Lower Saxony, Germany.


Why does your 1996 ford thunderbird pull hard to the left when braking even though you changed the roters out?

it could be either your wheel bearing or rack and pinion going bad


Where is the abs relay on a Ford Windstar?

i had alot of problems with my abs brakes so i took out all the brake light bulbs and disconected the battery then i pulled the 30 amp fuse under the hood that is for the abs brakes . then i reconnected the battery but the emergency brake on and started the van put it in drive and let the computer reboot otself there by, bypassing the abs all together after 1/2 hr turn car off replace the brake light bulbs remember the top light to and now your abs will not give you any more problems. make shure to have your brakes changed regularly the windstars are bad on brakes. allso have your roters cut with every new set of brakes rear drums as well bushmtn@yahoo.com


Would a damaged steering rack cause shaking of steering wheel?

It could, if the damage has caused a loose component or the alignment to be way off.if the sterring wheel is shaking while applying the brakes then most likey the brake roters need machining or replacing


Front of car shakes when braking?

roters need turned. 65;