i had alot of problems with my abs brakes so i took out all the brake light bulbs and disconected the battery then i pulled the 30 amp fuse under the hood that is for the abs brakes . then i reconnected the battery but the emergency brake on and started the van put it in drive and let the computer reboot otself there by, bypassing the abs all together after 1/2 hr turn car off replace the brake light bulbs remember the top light to and now your abs will not give you any more problems. make shure to have your brakes changed regularly the windstars are bad on brakes. allso have your roters cut with every new set of brakes rear drums as well
bushmtn@Yahoo.com
The 2000 Ford Windstar ABS relay switch is located on the firewall in the engine compartment. The relay switch will be on the passenger side of the engine compartment.
It is important to know where the fuses and relays are in a vehicle. The ABS relay in a 99 Ford Windstar is located in a fuse box under the hood.
where is air flow relay on 2000 ford windstar
On a 2000 Ford Expedition the ABS Relay problem is a problem with the braking system. Either the ABS Relay needs to be replaced or the brake pads are worn down. The ABS Relay is located in the fuse box that is on top of the battery in the engine compartment.
This could be referring to the ABS control module.See "Related Questions" below for more
On a 1999 Ford Windstar : ( relay # 207 is the fuel pump relay ) In the Power Distribution Box ( which is " live " ) located in the front of your engine compartment , near the battery
Anti lock ( antiskid ) braking system
in the gas tank
See "Related Questions" below regarding ABS wheel sensors - including how to replace them.
There is a fuse for almost every electrical part on the car. To disable the ABS system on this vehicle, the person needs to pull the ABS fuse or relay. On the diagram it will be labeled as ABS.
I believe that is in the relay box , in the engine compartment , BETWEEN the battery and the drivers side fender . The ( 2 ) larger relays are the ABS pump relay and the ABS main relay ( NOT the power distribution box / it's called relay module # 3 )
Pull the fuse. In 1996 Windstar, it's fuse #33