no your water pump should not be squeeling. it could possibly be that some water or coolant got on your belt, or I would also check all the other pulleys. the best way to do that is remove the drive belt, and grab each pulley and spin it. The only one that should not move will be the crankshaft( very bottom pulley). Spin them all and listen to them, you will hear if a bearing is bad in them.
The water pump, on a Chevrolet Avalanche 5.3 liter, can be removed by first removing the water hose. Remove the four bolts to the water pump cover. The water pump will slide out. Reverse the process to install the new water pump.
You can change the water pump on your 2000 Mercedes E3 20 by first removing the water pump belt. Next remove the water lines. Remove the bolts that hold the water pump in place. The water pump will pull outward and can be removed. Reverse the process to install the new water pump.
You first disconnect the battery, then drain the cooling system, discount belt from engine and water belt pulley, then remove the water pump bolts and remove the water pump, then you install the new water pump and put everything back.
I changed a Water Pump first by draining the Coolant and there are some bolts that need to be loosened to take the Water Pump off. Make sure you a Gasket on the New Water Pump and use sealant to prevent Coolant leakage.
Drain the water from the cooling system. Remove the belt from the water pump. Remove the water hose from the water pump. Remove the water pump retaining bolts. Apply a brand-new gasket and reverse the process to install the new water pump.
How long does a new water pump last on a 2002chevy suburban
the water pump seal is worn out you need a new water pump
Secure your new water pump with the water pump retaining bolts. Connect the water pump return hose. Put the belt on to the water pump. Top off your cooling system with new cooling fluid.
After I had my belts replaced my a/c belt squealed the next day. But I returned to have it adjusted (mechanic said it probably would need it) and it's been fine since. Belts loosen up just a bit when new, I was told.
i cant fully answer this question but first you should purchase a repair manual. i know when relacing a water pump you must first disconect the negative connection from the battery, release the pressure and drain the coolant. next you must remove the radiator ,coolant fan and any other things that inhibit the removal of the water pump. remember to purchase the new water pump with a new gasket included. and you will need silicone to seal the water pump when replacing. that's basic hope it helps
that means that the new water pump is defected
The water pump on a 1997 Hyundai Accent is replaced by first removing the timing belt and draining the coolant. The alternator needs to be properly marked and removed. Then unbolt the water pump. Clean off the old gasket and install a new gasket with the water pump.