0
Does any one have a parts break down on the valve body for 99 elantra trans model A4AF2... of the C-clips that hold valve-body VALVES in place two fell out and can't figure from where.?
Wiki User
∙ 16y ago
You scan the body.
Wiki User
∙ 16y ago
Add your answer:
Earn +20 pts
How is a timing belt for a 1999 Hyundai elantra?
how to time a 1999 Hyundai elantr glsAnswerhow to set timing belt on Hyundai elantra gls figure
When and why should you used the OD in an 2000 Elantra Hyundai?
Leave it in OD all the time. The computer will figure it out for you.
How do you change the front brakes on your 2003 Hyundai Elantra?
quoted $300 for front brake pads, figure I can do no own for less
Ihave a marching baritone and its the schools and the valves are being ghey the wont go back intoth baritone and i dont know the order to put them in. help?
I used to play trumpet, and sometimes I'd take the valves out when washing out the instrument. And yes, the valves wouldn't go in if you put them in the wrong order. But with three valves, there are really not that many possibilities. With a little experimentation, you should be able to figure it out, LOL!
Bought a 1999 Hyundai Elantra without any documentation with 73k miles How to figure out if the previous owner changed the timing belt at 60k?
look for signs of not all parts put back on (missing bolts)
How many hp in 800cc engine?
We would need more information to figure that out. The compression, airflow capabilities at the valves, ignition timing and duration, fuel delivery system ect.
How do you install power steering belt for 2000 Hyundai Elantra?
one screw on top does it but you have to take the other belt off first which is one bolt as well - since you cant figure that out - i suggest you not doing it since this seems over your head.
Where is the flasher located LF12 on a Hyundai elantra 2000 so you can replace it and your blinkers flashers will work again?
the flasher is located underneath the hood..what you will have to do tho is locate the fuse box and figure out which relay is blown because there are like three that look the same
Radio dome light automatic locks quit working in 02 Hyundai elantra fuses are fine what else could it be?
I got this same problem. some part of your wiring is bad. Its a real pain to figure out what part some of it is wired to the clock some is wired to the heating plug and some of it is just out there.
What is the flow rate of water in a 0.75 inch pipe at 30 psi?
There are a lot more factors that must be considered in order to give you an accurate number, such as the length of pipe, type of pipe, number of valves in line, tees, elbows. Water pressure will drop as the water flows along the line, and as it encounters turns, valves, tees, sprinklers, etc. I'll give you a rough estimate of 23 gpm, but this is an extremely rough estimate. You will need to figure out the complete layout with all valves, turns, sprinklers, etc, then consult an expert to get a better estimate.
How do you figure out if your lifters are to tight?
well the lifters shouldn't be too tight if they are the correct lifters for your vehicle. if your having problems with your valves opening its probably because your rocker arms are torqued beyond specifications. buy a manual and loosen your rocker arms torquing to specs.
How do you figure out which valve is the high or low on a 1976 Grand Marquis it isn't labeled and both valves look the same?
High side is discharge and is always the smaller diameter hose. The low side is suction and is always the larger diameter hose. This is true for all refrigeration.
