Are you certain that you want to block off the crankcase ventilation?
Without a place to escape, exhaust gasses that leak past the pistons and into the crankcase will build sufficient pressure to blow out the main seals and possibly a few gaskets as well. You might want to think this one through first.
There is a breather plate inside that has a small hole, if I remember correctly that little hole needs to be near the bottom. The plate can be installed upside down if your not careful then oil leaks.
A plate block is a block of stamps from the edge of the sheet which shows the plate or cylinder from which the stamps were printed.
A home plate collision is usually the case of a base runner that was on one of the bases trying to reach home plate in order to score while the other team's Catcher is trying to block home plate in order to prevent the base runner from touching home plate in an effort to prevent a run from scoring and the runner and the base runner usually slides into the Catcher that is blocking home plate which is what one example of a home plate collision is.
Every Chevrolet V-6 engine block has a metal plate attached to the engine block, listing the specifics of the engine. The casting numbers should be on the engine block plate.
To my knowledge the only small block flex plate that doesn't interchange is the small block 400.
it is a huge block of earth's crust
You scrub bacteria on the sides and plate of the microwave.
Fault-block
Fault-block
fault-block
No. That would be an obstruction and the base-runner would be safe.
clutch plate,pressure plate,throwout bearing