In the '03 Owner's manual, a rather poor picture shows the oil drain bolt at the bottom right rear of the engine; it's axis is parallel to the ground, fore and aft. If the picture is correct "Engine Oil" label is cast into the bottom casting at the bolt. Directions are to run engine to normal temperature; lift hood, remove engine oil fill cap. Remove drain bolt and washer from the bottom of the engine. Remove the oil filter and let the remaining oil drain; a special wrench is needed for the filter. (I'd guess a normal oil filter wrench will work. )
does anyone know where a starter is located on a 98 acura 3.5 RL
I'm trying to remove the fuel tank of an Acura 97 tl 2.5, How I can do that?
The 1999 Acura TL OBD 2 port is to remove ashtray
The starter on a !996 Acura is on the passenger side near the firewall. It is above the exhaust and is difficult to remove.
You can remove the governor on an acura integra by having the ecu chipped.
The PCV valve on the 2001 Acura TL is located on the top of the rear valve cover. It's easy to replace - simply pull it out by hand and remove the attached hose. You have to remove the black plastic cover on top of the engine to access it.
A 1998 Acura Integra fuel pump is located under the car. If you jack up the vehicle and get under it and remove the fuel tank the pump will be located inside the fuel tank.
in front of engine must remove the timing belt covers
located behind the glove box. Remove glove box.
check behind the shifter lever and remove tray.
How to remove starter on 2002 Acura 3.5 RL
where is stater located on 1997 acura 3.5rl.
Where is the VSS located on a 99 acura TL
how to remove gas tank from acura tl 1996
It is located between the back seat and the spare tire hole remove 4 screws for the cover plate and your there .
where is the ignition module located ina 2000 integra acura
The brake lights are located in the trunk of a 1997 Acura Integra. To replace them open the trunk and find the plastic housing. Remove and replace the bulbs.
where is the umc fuse located on a 97 acura tl
When changing the lights on a 1995 Acura Integra remove the dash on the center console and pull it off. Remove all the accessories and reach the old bulbs. Replace the bulbs.
The sensor is located on the intake manifold or air plenum. It is removed and installed in straightforward fashion; disconnect the wiring connector and remove the mounting screws. Remove the sensor.
acura mdx 03 right side rear door panel how to remove
if its an 88 acura legend then you will need to remove the couple of bolts that hold it down and take it to the local auto store. like other cars you can just replace the bulb but on these acura you need to replace the whole headlight unit
is located under the ashtray behind the shifter ,remove piece of plastic and the obd ll connector is there
Locate thermostat on 1996 Acura RL