Resistance is not affected by either voltage or current. It is determined only by the cross-sectional area, length, and resistivity of the material. As resistivity is affected by temperature, resistance is indirectly affected by temperature.
In the so-called 'Ohm's Law' equation, resistance is a constant. So, if you increase voltage, the resistance remains constant, and the current would increase in proportional to the voltage.
Yes since voltage, current and resistance are all related by Ohm's law where Volts = Current x Resistance. So as Voltage is increased, current would increase proportionally.
The resistor allows current to enter the electromagnet in an electric motor. The resistor regulates the amount of current that enters the electric motor.
.The magnitude of the voltage and current of both the armature and shunt field coil. To decrease the speed when the load is increasing then increase the shunt field current while decreasing the armature voltage or current. To increase the speed while the load is increasing then increase the armature current while decreasing the shunt field current. The decreasing and increasing of these currents and voltages can be done by connecting a variable resistor in series or parallel with each of the armature and/or shunt field coil.
In an electric circuit, ratio of current and voltage is constant which is known as the resistance of the circuit. If voltage or current is to be changed the resistance has to be changed. You cannot keep an invariable resistance in the circuit and increase current while keeping voltage as constant.Hence to vary the voltage or current in a circuit different equipments like rheostat,potentiometer are used.
increase.
Resistance is the property of a component which restricts the flow of electric current.
no
Your question lacks detail but, in general, increasing the load will increase the current.
The resistor allows current to enter the electromagnet in an electric motor. The resistor regulates the amount of current that enters the electric motor.
If the load resistance is constant, then increasing the voltage will increase the current by the same proportion -i.e. doubling the voltage will double the current.
Current moving through a resistor causes it to heat up because of the flowing electrons bumping into the atoms in the resistor.
Resistor is a component of an electric circuit that resist the flow of direct or alternating electric current . It can also limit or divide the current, reduce the voltage, protect an electric circuit, or provide large amounts of heat or light.
Limits current flow and drops voltage.
If you're talking about an electric motor, increasing the frequency will increase the speed of rotation of the motor, and decreasing the frequency will decrease the speed of rotation of the motor. The other way of controlling a motor is to control the current; increasing the current increases speed, decreasing current decreases speed.
.The magnitude of the voltage and current of both the armature and shunt field coil. To decrease the speed when the load is increasing then increase the shunt field current while decreasing the armature voltage or current. To increase the speed while the load is increasing then increase the armature current while decreasing the shunt field current. The decreasing and increasing of these currents and voltages can be done by connecting a variable resistor in series or parallel with each of the armature and/or shunt field coil.
It depends on the purpose for installing the resistor. If the intent is to decrease current flow, the resistor must be connected in series with the load. If the purpose is to increase current flow, the resistor must be connected in parallel with the load. To connect a resistor in series, connect the resistor to one side of the power source, in line with the load. This will decrease circuit current flow. To connect a resistor in parallel, connect the resistor between the positive and negative sides of the power source, which will effectively connect the resistor across the load . This will increase current flow through the circuit. However, before connecting a component in parallel, make sure the increase in current flow will not exceed the current rating of the circuit or fuses/breakers will blow.
Increasing the number of loops per meter in the coils of a solenoid is one way to increase the wire's electric current.
In an electric circuit, ratio of current and voltage is constant which is known as the resistance of the circuit. If voltage or current is to be changed the resistance has to be changed. You cannot keep an invariable resistance in the circuit and increase current while keeping voltage as constant.Hence to vary the voltage or current in a circuit different equipments like rheostat,potentiometer are used.