No
A: This term refers to the FM band or frequency range.
30 MHz to 300 MHz
This frequency range is used for A.M Radios specifically M.W(Medium Wave) Band. More information of MW band will be on http://en.wikipedia.org/wiki/Medium_wave
Broad band is a given range of frequencies, starting at a lower frequency through to an upper frequency, Base band is usually a specific frequency on which various modulation methods can be employed. But it too, can have a frequency range, or `band width' that considered part of the base band but yet called a single frequency based on the frequency's `center frequency'. A base band frequency for instance that's used in analog TV transmissions can range from 6 to 8 megahertz wide, on which the video, sound, color and other information is imposed. Broadband, usually used in computing terms, usually implies something like a DSL modem that can work from a few bits per second up to thousands of bits per second. It can either be wired or wireless, much the same as with a base band system.
Upper sideband = Carrier frequency + modulating frequencyLower sideband = Carrier frequency - modulating frequency
The AM radio band falls in the comparatively low frequency range of 550 to 1600 KHz while FM radio operates in the 88 to 108 MHZ range and CB operates in the relatively narrow range of 26.95 to 27.405 MHZ. Cellular telephone operates in a frequency band of 825 to 890 MHZ.
From 88.5 to 107.9 MHz
It depends on the fundamental frequency. If for example you wanted to find how many harmonics a 20 Hz sound has then its all the integer multiples of that frequency which are still within hearing range, i.e 20000 Hz. For 20 Hz this is 20000/20 = 1000 harmonics.
it is range of frequency variation for which governor does not take any proportional corrective action.
The lowest frequency is effectively zero and this would be in the extremely low frequency (ELF) band in the sub-radio range of the electromagnetic spectrum.
A: An amplifier while capable to amplify a whole range of frequencies sometimes some of this frequency are not needed or wanted in a specific range or [BAND] so it is designed to either pass this band or reject this band of frequencies.
ANSWERED MY MUHAMMAD WALEED SHAIKH first of all we have to know that about band,so band is range of frequency which we have selected for example:we have a low pas filter it frequency always started from initial or 0 HZ upto cutoff frequency and here remember that cutoff frequency we will have to select after cutoff signal is rapidly down now about band rate so your signal is band at certain rate is called band rate.