Yes. solder is very flexible and soft.
I would take out the lead bend and replace it with pvc.
Yes: flux core solder is. No: acid core solder is not.
Six types of bad solder connections include a cold joint with insufficient wetting (Pin) or insufficient wetting (Pad), a disturbed joint, an overheated joint, too much solder, or not enough solder.
SN63BS is SN63 in Bar Solder form
A Conductor, SOLDER IS NOT AN INSULATOR. The most common types of solder are made of tin and lead. Another type is silver solder. All of the materials used are metals and are good conductors of both heat and electricity. If you solder something you would notice if you ever held a wire (without protection) while applying solder to it your finger would probably receive a burn (speaking from experience).
I would eliminate the lead bend and replace it with pvc. The lead bend is a ticking time bomb why play with it replace it.
I would take out the lead bend and replace it with pvc.
with solder
Yes, usually no problem. If you know how to solder, then solder away.
In some solder it is. But even if it is in the solder you should still use flux.
Yes: flux core solder is. No: acid core solder is not.
Solder is a metallic alloy
solder is use for to make jewles
Depends on the kind of solder.
Six types of bad solder connections include a cold joint with insufficient wetting (Pin) or insufficient wetting (Pad), a disturbed joint, an overheated joint, too much solder, or not enough solder.
A reel of solder used for joining electrical circuits together on circuit boards. Solder is made of a mixture of tin and lead and sometimes has has flux (a form of acid) in the core of the solder to ensure a clean surface for the solder to flow into.
he is in boot camp traning