Want this question answered?
Inside the distributor cap under the rotor.
Look [http://autorepair.about.com/od/enginefiringorders1/Engine_Firing_Orders.htm Here for your Answer]
No there is not, Probley need to replace ingnition module in the distributor if the injectors are not working.
The module is located behind the Rotor Arm assembly in the distributor itself. You have to remove the Distributor Cap, then the Rotor Arm and the module is there.
I would first check and probley replace the pick coil that is in the distributor, That is the item that the ignition module plugs into. You will have to take the distributor out and apart to replace it.
It could be either the crank angle sensor or the distributor module. If it is the distributor module, you have to buy and install a re-man distributor.
The ignition module is located in the distributor, under the distributor cap.
I'm working on a 1987 Festiva, and I *believe* that this is located inside the distributor housing.
Most likely it is the TFI module mounted on the back side of the distributor. Takes a special tool to remove it, available at auto zone for about 5 bucks.
ignition module is located under the distributor, where the spark plugs come out to go to the spark plugs, remove 6 bolts that hold the 3 capped distributor on, unplug the wires from both ends of module, 3 plugs, lift module out, nothing holds it in after distributor is removed, plug new module in, replace distributor.
The ign. control module on a 2.8L s10 is in the distributor. Remove the distributor cap and it is attached to the base of the distributor
No.No.