Hi: Your question is a good one and fairly easy to answer. Most systems are matched in their in general design critieria so that the air flow will be ample for both the size of the cooling design ( AND ) the heater air flow demand. Mix matched systems do exist but you should always use professional guidance before attempting one as that safety issues are prevailant. Mostly concerining adequate air flow. P.S. Typically heating systems use lower speed fan setting for heating application and faster for cooling. Some Mfg.s, simply use just the high speed for both. The design criteria specs. you would look for to make your decission would be C.F.M. per Minute per Pressure drop loses designed in the overall duct design. Hope this is helpful, Jimiwane
Maybe. The coil is not matched to a 2 or 3 ton truck It is matched to the engine and igniton control system. So it may be the same part #.
To calculate the coil length, you need to convert the coil size and its weight to the SI units.
Yes it will. Typically a coil is sized a 1/2 ton larger than the a/c out side for efficiency, but a whole ton bigger should still work
Yes it will. Typically a coil is sized a 1/2 ton larger than the a/c out side for efficiency, but a whole ton bigger should still work
I'm not an air conditioning expert, but I would expect that the compressor will run a lot more than it needs to. A 2 ton coil will not cool as much air as a larger capacity 3 ton coil. Experts?
Between $490-765. That's a range for a 2 ton to 5 ton residential a/c coil cleaning.
yes it can. you can you can only downsize a coil by .5 tons or up .the flowrator piston have to be be changed according the the condenser size don't ever try to go more than1/2 ton it would damage the system.
yes it can. you can you can only downsize a coil by .5 tons or up .the flowrator piston have to be be changed according the the condenser size don't ever try to go more than1/2 ton it would damage the system.
The rating is technically a minimum. You could use a larger coil and have it work. But if its a Evaporator coil it will need to be matched on the far end with a similar or larger condenser coil. If the Condenser coil is larger it will probably just take a little more refrigerant.
It could have any size heating furnace, the two are unrelated except for the size blower used in the furnace to support the 3 ton cooling system. But the fact remains you can get a 3 ton blower in 50,000 btu furnace, a 100,00 btu furnace and anything in between.
a tonne is the same as a ton there is no diffrence
The 1996 GMC half ton pickup truck heater core can be removed by removing the heater core retaining bolts. Remove the heater core water lines. Reverse the process to install the new heater core.