it is possible they are just formed plastic tubes molded on to the heater core then run out on bottom side of firewall in the middle. there should be hose clamps on at this fitting end.
wolverine
if you want to hold it down use some clamps
A clamp stand is used in a laboratory to secure equipment while they are being used.
Secure them down with pipe clamps or nail them down with nails and screws
Connect the wiring harness to the back of your new speakers. Secure the speakers into place with the retaining screws. Put the speaker cover on and secure it into place.
secure heating, ventilation, and ac system, circulating fans, and air handlers
a utility clamp is used to secure an extension type utility clamp to a support stand
There are several ways to remove a hardtop from a hardtop convertible. Some are held on by clamps in the front and back. Releasing these clamps allows one to remove the top for storage in the trunk or garage. Others only have clamps along the front windshield. One would undo these and manually fold the top back and secure it behind the seats. Lastly, some are power hardtops that are folded back into the trunk with the push of a button.
What low-cost heating and cooling options are there for a house? Well blinds are a way to go. Always have the window open, make sure everything is secure and there is no draft.
PVC pipe fittings are used to connect and join different sections of PVC pipes together. They provide a secure and leak-proof connection, allowing for the smooth flow of liquids or gases through the pipes. These fittings come in various shapes and sizes, such as elbows, tees, couplings, and adapters, and they can be used for a wide range of applications, including plumbing, irrigation, and construction.
I am a Plumbing/HVAC Contractor and the type of fitting I always used for underground copper service pipe has been 3/4" (standard size for residential) brass flared fittings. A flared connection is a tight, secure connection guaranteed not to leak.
between the air cleaner housing and the throttle body check all air tubes to be sure clamps are tight and secure
The air filter is located inside a housing at the right (passenger side) of the engine compartment. Lossen the clamp securing the inlet tube to the air filter cover, relase the clamps that secure the two halves of the air cleaner housing together. The air filter is located inside a housing at the right (passenger side) of the engine compartment. Lossen the clamp securing the inlet tube to the air filter cover, relase the clamps that secure the two halves of the air cleaner housing together.