0
Does the starter have to be removed on a 93 Saturn 1.9 ltr sohc to replace the crankshaft sensor?
Wiki User
∙ 17y ago
NO you can replace it without I't's just a 10 mm head bolt but you will need pliers or a screwdriver to "help" the sensor out The "O" ring will be tight
Wiki User
∙ 17y ago
Add your answer:
Earn +20 pts
How do you replace a starter for a 1992 Saturn SC2 Standard?
how to replace a starter on a 1992 Saturn 4 door car standard
How do you replace a crankshaft seal on 2003 Saturn Ion?
Very carefully
Where is the crankshaft sensor on a 2000 Saturn sl2?
The rear crankshaft sensor is located on the back of the crankshaft. The rear engine cover will need to be removed in order for the sensor to be visible.
Where is the crankshaft positon senor on a 99 Saturn sl2?
firewall side of motor above starter 10mm bolt
Where is the solenoid located on a 93 Saturn sc?
The starter solenoid is attached to the starter. When you replace the starter, you'll get a new solenoid.
How much money to replace a starter on a 2004 Saturn Ion?
how much to charge to change a stater on saturn
Location of crankshaft position sensor 2003 Saturn L200?
The 2003 Saturn L200 has a camshaft position sensor. It is located on the bottom front of engine behind the Starter. You will need to remove the two bolts that are holding the Starter to get to the sensor.
How do you replace a starter on a 1998 Saturn?
http://youtube.com/watch?v=be4PzzAxniI video by richpin
Intermittent starting 1996 Saturn?
Solenoid going bad remove and replace starter assembly.
How do you change crankshaft sensor in a 2001 Saturn sl?
were is crankshaft sensor located in 2001 Saturn l300
What is the Location of crankshaft position sensor on 2002 Saturn Vue V6 AWD?
above the starter bottom front of engine has one bolt using ten mm may have to remove starter to access
How do you replace a starter on a 2000 Saturn SL1 sedan 1.9l and how many bolts hold it on?
Remove the positive battery cable from your 2000 Saturn battery. Remove the cables from the front of the starter. Remove the three starter retaining bolts. Reverse the process to install the new starter.
