A: Believe it or not that is the only time that it is useful
zener diode is a special type of pn junction diode that work in breakdown region . There are two types of brekdowns in zener i.e avlanche breakdown and zener breakdown depending on the doping concentration. A zener diode in an on state can be considered as a voltage source ,equal to its zener voltage n hence act as an voltage regulator
zener breakdown and avalanche breakdown.
A: A zener is a diode that when connected in the reverse mode current direction it will breakdown to a predetermined voltage any further increasing voltage the breakdown will remain practically the same.
A Zener Diode will continue to show its breakdown characteristics until it gets fried...for example a 5 volt zener will get fried at a breakdown voltage of about 6 volts..this happens because of the large amount of current flowing through the small diode which unfortunately the diode cannot handle.
breakdown condition
zener diode is a special type of pn junction diode that work in breakdown region . There are two types of brekdowns in zener i.e avlanche breakdown and zener breakdown depending on the doping concentration. A zener diode in an on state can be considered as a voltage source ,equal to its zener voltage n hence act as an voltage regulator
zener breakdown and avalanche breakdown.
Yes **************************************** Yes they can but there are pitfalls. A normal diode will have a high reverse breakdown voltage. A zener has a relatively low breakdown voltage (its "zener"voltage). If a zener diode is used as a rectifier it must have a zener voltage at least twice the peak of the applied a.c.
The zener diode protects the meter by stabilizing the voltage when it goes in to the breakdown region.
A: A zener is a diode that when connected in the reverse mode current direction it will breakdown to a predetermined voltage any further increasing voltage the breakdown will remain practically the same.
A Zener Diode will continue to show its breakdown characteristics until it gets fried...for example a 5 volt zener will get fried at a breakdown voltage of about 6 volts..this happens because of the large amount of current flowing through the small diode which unfortunately the diode cannot handle.
breakdown condition
After breakdown voltage is reached in a zener diode the current increases drastically.
False, a zener diode is normally operated reverse biased in breakdown.
If the zener diode is in zener breakdown the voltage across the zener diode remains constant regardless of current (for the ideal zener diode). Real zener diodes have parasitic resistance that causes the voltage across the zener diode to increase slightly with increased current, but due to temperature dependant variations in this parasitic resistance as well as temperature dependant variations in the zener breakdown voltage, this change in voltage in real zener diodes cannot be described by a simple linear factor.
The function of a zener diode is for it to act as a voltage regulator in the breakdown region.
Yes. The intended use of a zener diode is to be reverse biased at the breakdown voltage. In this mode, the zener has high slope in the current to voltage curve, making it a good choice for voltage regulation.