answersLogoWhite

0


Best Answer

Pry the arm off the spindle and reposition it a couple of teeth in they direction you want it to stop. There are usually around twenty teeth on the spindle so you can really fine tune the adjustment relatively easy.

User Avatar

Wiki User

14y ago
This answer is:
User Avatar

Add your answer:

Earn +20 pts
Q: Driver wiper not going all the way back down?
Write your answer...
Submit
Still have questions?
magnify glass
imp
Related questions

Where is the wiper motor on a 94 jeep wrangler yj?

The wiper motor is on the driver's side, behind the dash board. if you fold you front windshield down, that will expose your wiper motor.


Where is the location of the wiper motor on a 95 jeep wrangler?

the wiper hooks directly to it open the hood, look straight back towards the windsheild. You will see them sticking down or slanted.


The windshield wipers on a 244 Volvo are going down instead of upwards so what is the problem?

you need to remove the blades,turn on the wiper motor let it go through the circulation then turn off the switch , this is to make sure the wiper motor was in correct position when they were installed then put them back on and try it again


1987 Honda Accord Intermittent wiper relay location and part number?

The wiper relay is behind the fuse box which is under the dash to the left of the driver side, its huge. also the flasher is down their and some other relays are their as well


Install wiper arms 1995 Pontiac Bonneville?

The wiper arms are held on by a spring clip. Use a screw driver and pry the tang at the base of the wiper arm and lift up on the arm. When you have the tang pulled out far enough it will hold the wiper arm up off the windshield. Then you gently pry the outer edge of the wiper arm base up while gently wiggling the arm up and down. It should pop right off. Note: you might want to mark the position to be sure you put it back in the same spot or it may not park properly.


How do you reconnect the wiper arm to the wiper motor after new wiper motor has been installed?

Very simple, note down the color of the wires of the harness coming from the motor going to the connector on a piece of paper. Based on that connect the wires from the new motor to the connector. Vikram


1997 Ford f-150 windshield wiper fuse location?

First row going down #6 30 mamp


What's the easiest way to remove the wiper arms on a 1987 Mustang?

Pull back on the wiper arm softly until it is fully extended. There is a small clip that slides back to release the arm. Slide it back and pull the wiper arm off. Be sure to note position of wiper arm so install will be in same position. Install is with arm fully extended,clip slid in, then place back on post. Softly pull back on arm a little then slide out clip push down and release?


red scratch looking line going down back of neck?

red scratch looking line going down back of neck”


How do you release a 1998 Mercedes Benz E230 wiper blade assembly which was locked in a raised position during car washing?

All you have to do is push the wiper blade assembly back down, it has a pretty strong detent when its in the up position, so dont be scared, just give it a good strong force back down, and it will go.


How do you change the wiper blades on a 1996 camaro?

push the piece of plastic down. push downward (with wiper up) and it will slide down


How do you remove the wiper blade from the wiper motor?

There's a hole on the end of the wiper rod , that's the rod were the wiper clicks in to. there should be a tab next to that hole , press down on that tab to release the wiper.