0
What engine ?
Wiki User
∙ 15y ago
Add your answer:
Earn +20 pts
Where is the starter on 91 Pontiac sunbird 2.0L and is it easy to change?
You can find the starter at the lower front part of the engine. You can change starter easily any time it has a fault.
Where is the starter in a 1993 Ford Mustang LX?
Depends on the motor (5.0 or 2.3) but both are located on the right side. On the 2.3 it is directly under the exhaust manifold. Same with the 5.0, but you will have to actually remove the header on the 5.0.I had a 5.0 with longtube headers and had to take it all apart to get to the starter, but I also have a 2.3 and its a fairly easy job to replace.Thanks.
How do you change a starter on a 1993 S10 Chevy Blazer with a V6 4.3 liter engine and automatic transmission?
The starter is bolted to the engine by two bolts which makes it very easy to change, just remove the bolts and drop the starter down until you can remove the wires from it, it is a good idea to remove the negative battery cable before starting the job to prevent arcing the wires to ground.
Do you have to remove engine to replace starter on 1994 Ford Mustang?
NO very easy actually, remove Battery Cable,H-Pipe, 2 bolts and 2 wires.
Easiest way to change fuel pump on a 88 mustang gt?
no easy way, you must drop the tank
Is it a big job to change a starter in a 1988 cad deville?
No, this is a pretty easy repair, Make sure you disconnect the battery before removing the starter.
Where is the starter located on the 1993 Chevy Cavalier V6 2door?
Your Starter is located at the front of the engine near the transmission. You need to take off two wires running to the starter and then two bolts holding it on. It's very easy.
How do you change fuel filter on 2002 mustang?
Very easy Take the old filter off and replace it with the new one.
How easy is it to change a fuel pump on a 1993 Nissan pickup?
Not easy at all. Fuel tank must be removed.
How do you change the starter on a 2000 Daewoo leganza?
The Starter is not easy to change. First thing " Disconnect the battery". The starter is under the intake manifold and bolts into the transmission. You need to remove the intake and all related hoses and plastic parts as well as the hard plastic cooling pipe that basically sits above the starter. There are 2 bolts that hold it in and one is easy to get at and the other is a bit more difficult.
Is it easy to change a starter on a 1989 olds cutlas s51 seden?
Disconnect - battery terminal Raise and support vehicle Disconnect wiring at starter Remove 2 mounting bolts Drop starter
How do you change starter on 92 jeep wrangler 4 cylinder?
Easy enough, 2 torx bolts going straight up from the starter, and dont forget to unhook the electricals.
