0
What about them?
Wiki User
∙ 14y ago
Add your answer:
Earn +20 pts
Where are engine timing marks on Honda qa 50 engine?
Pull the chrome cover of the left side of the motor the timing marks are on the fly wheel. An F and a T.
What causes a 1993 5.0 mustang gt with the 302 engine backfire between 50 to 70mph?
Unburned fuel is igniting in the exhaust, you may have a fuel metering problem, or a timing problem. If the timing chain is stretched it could throw off the spark timing at high rpm.
Proper position of piston on a 2.7 engine after water pump replacement?
When the marks on the timing chain are lined up properly, the piston is about 50 deg after top dead center.
What is the coolant capacity for 1969 ford mustang with 351 engine?
4 gallons 50/50 anti-freeze/water
Does a 1990 dodge ram 50 have a timing belt or chain?
In a 1990 Dodge Ram 50 pickup both the 2.4 litre four cylinder engine and the 3.0 litre V6 engine uses a timing BELT
What kind of antifreeze goes in a 2004 mustang?
According to the 2004 Ford Mustang owners manual : It came from the factory with a 50 / 50 mix of distilled water and Motorcraft Premium Gold Engine Coolant ( YELLOW colored , meeting Ford specification WSS-M97B51-A1 ) in the engine cooling system
Where is the timing belt on a ford 429 engine?
A Ford 429 engine does not have a timing belt. As a V8 engine, it uses a timing chain that is located on the front of the engine behind the crank pulley, the water pump, and the timing chain cover. If you've little experience working on big block V8s then I'd suggest paying a mechanic (make sure he's in his 50's or he won't know how to do it!) to replace the timing chain.
How do you convert 50 marks to 20 marks?
50/100 *20
Why does my1994 mustang gt check engine light goes on and off?
It probably means that your radiator fluid is low. If it is just buy a gallon of 50/50 and top it off.
What enabling the 2.7 to start if tdc is about 50 degrees past should the timing on the crank shaft be set somewhere in the general area?
When the marks on the chain and the marks on the sprockets are lined up the piston is after tdc. This is how it is supposed to be. Just align the links on the cahin with the proper marks on the sprockets.
How do you time 1987 Suzuki Samurai?
but seriously, that's why God invented timing lights. Shine them on your crank pulley. The manual with the timing light should explain things betterremove rubber plug from transmission bell housing located on drivers side .start the engine and warm engine to normal operating temperature (failure to warm up engine to proper temp will result in incorrect timing) after warming engine make sure that idle is set to spec 800 +or-50 rpm (failure to set idle to spec will cause incorrect timing) connect timing light to spark plug wire number 1 .now looking at the bell housing opening where you removed the rubber plug in the middle towards the back of the opening there is a notch this is your timing match mark.on the flywheel is your timing marks for 86,87 samurai timing should be set at 10 deg b.t.d.c-_
What type of antifreeze does a 2006 mustang use?
Originally from the factory it had a 50 / 50 mix of Motorcraft Premium Gold Engine Coolant ( yellow color ) and distilled water Ford specification ( WSS-M97B51-A1 )
