0
To remove the fan clutch in an 04 Ram 1500, hold the fan in place using a special fan removal tool. Turn the nut to remove the fan. The tool should be able to be rented through a local auto parts.
Wiki User
∙ 9y ago
Add your answer:
Earn +20 pts
How do you remove or free the fan clutch assembly on a 1996 Dodge Ram Van?
With a fan clutch removal tool from an auto parts store.
Fan clutch removal on 2003 dodge ram?
It requires a 36mm wrench and a spanner/holding device. The fan clutch unscrews counter clockwise.
How do you replace a clutch fan on a 2004 dodge ram 1500 Do I need any special wrenches to be able to do this?
It requires a 36mm wrench and a spanner/holding device. The fan clutch unscrews counter clockwise.
How do you check 2003 ram 5.9 fan clutch?
how do you check the fan clutch not working on 2003 ram 3500 5.9
Is the clutch on a 1500 Dodge Ram adjustable?
Not since about 1985
How do you tighten the clutch on your 2000 dodge ram 1500?
It is not adjustable.
How do you change fan clutch on 3500 ram 5.9L does it take a fan clutch tool?
Yes it takes a 36mm wrench and a holder for the pulley to remove the fan clutch,
Why is my Dodge Ram over heating?
Check clutch fan
Does the 2004 ram diesel have an electric fan clutch?
Yes, it is an electrically controled mechanical fan.
How do you change the clutch on a 2001 Dodge Ram 1500?
Raise the front end of the 2001 ram 1500. Remove the drive shaft and transmission. Unbolt the clutch, and check the pressure plate for wear. Using an alignment tool, install the new clutch. Reverse the procedures to finish the installation.
How do you change a water pump on a 1989 dodge ram van?
Remove the serpentine belt, break free the fan (borrow a Clutch Fan Removal Kit from Autozone or Advance Auto Parts), remove fan shroud, remove fan entirely, disconnect hoses from pump, unbolt.
How do replace the water pump in a dodge ram 1500 5.9 v8?
Disconnect the battery. Using a clutch fan tool, hold the clutch to loosen and remove it. Remove the fan shroud. Drain the radiator. Remove the water pump belt, then the pump. Install the pump and reverse the process to finish the process.
