First check that the throttle return spring(s) on the motor are intact and functioning. Next use a spray grease to lube the entire throttle assembly (white lithium based is best), move the throttle assembly by hand to see if it moves freely.
If it does move freely test it by using the gas pedal. If the pedal doesn't move freely, or the throttle stays open when the pedal is pressed the throttle cable is likely corroded inside. Replace the throttle cable & lube the pivot for the gas pedal.
If you've recently done any work under the hood retrace your steps. Did you have the air cleaner off? If something, like a screw or socket, fell into the intake it's possible it got sucked into the throttle body and is lodging open the throttle plate, which is connected to the accelerator cable.
You stick your hand in the L drive, close your eyes, and hope for the best. God be with you.
Chances are the throttle cable from the pedal to the throttle body needs replacing.
Stuck closed, you cannot. Stuck open, you are foolish
A sticking accelerator is usually the result of binding throttle cables or a broken return spring. Make sure that these items are ok as a stuck accelerator can be dangerous.
Turn the ignition off.
NO
put the car in neutral
You should not reach down and pull the accelerator with your hands. point blank switch to lower gear
put the vehicle in neutral, pull over and shut off engine. then look to see why the pedal stuck
You replace them!
What to do when impeller is stuck on jet ski
A web accelerator does many things. A web accelerator is a proxy that reduces web sites access times. This can fix slow computers. It improves your internet connection by making it a run a bit smoother and faster.