Yes!
10 deg. BTC if it an automatic and 6 Deg. BTC if manual trans.
three --- two on passenger side one trans mount on drivers side
Both ways however it's easier if you remove subframe with motor/trans still attached to it you will need a table jack to hold it
Henry Ford - Creator of the Ford Motor Company.Henry Ford - Creator of the Ford Motor Company.Henry Ford - Creator of the Ford Motor Company.Henry Ford - Creator of the Ford Motor Company.Henry Ford - Creator of the Ford Motor Company.Henry Ford - Creator of the Ford Motor Company.
Contact an auto wrecker or dealer for transmission applications. Ford made many changes to these transmissions.
yes, a very good match. this combo started in the mid sixties with the Ford Mustangs. I have had several with a c-4/c-6 tranny. yep, take a c6 trans, and use a c4 bell housing.
If the trans is in a ford ranger it is more than likely a ranger trans
Depending on the car model let's say a Mazda mx6 and ford probe have the same engine and trans configurations from yrs 93-97 plus suspension components brakes fuel tanks also the mx3 has the same motor but only in v6 form some millenias also have some compatible motor n trans configurations
no,the 96 is electronically controlled,the other trans is not
If it is a v6 motor left side of trans on starter if it clicks when trying to start sometimes you can peck on starter motor to get started but will stop working again will need replaced
No, not the same.