probably not,they are pressed into engine block,you are talking "oil" dipstick tube. I have had some luck spraying rust breaker or wd-40 and gently wiggling alot until they come loose. Others i had to tap out with a steel rod fom oil pan side and drive them out. GOOD LUCK!!
The rear seat is not designed to be removed. You can remove the center seat and slide the rear seat forward.
The engine and trans are removed together out the bottom.
To remove the back seat from a 1997 Honda Odyssey the seat locks need to be opened. When the clips are unlocked the seat will be able to be lifted up and removed from the vehicle.
The rear seat is not intended to be removed. You can remove the center seat and slide the rear on forward into it's place.
The water pump housing can be removed by removing the three retaining bolts. The gasket can cause the housing to stick. You might need to pry the housing off.
The engine is removed out the bottom. You lower the engine and transmission out the bottom at the same time.
The rear seat isn't designed to be removed. If you have a center bench seat you can remove that by unclipping it, then slide the rear seat forward.
After removing the 2 bolts...remove the side marker light as well, then slide the headlight assembly toward the fender(about 1") then pull towards you, to release it from the frame. It should pop right out on top of you.
In order to remove a dash from any vehicle you will need to do one of two things. First, take it to the dealer to get it removed or look at the manual instructions to see if they explain how to remove it or if you can remove the dash.
How do I get the front grill off my 1997 Chevy suburban? I've removed the six visible screws holding it in place, but it still won't come out..
Open the trunk and remove the nuts holding the assembly in place. With nuts removed the tail light assembly will come out the back then you can remove the light socket to replace the bulb.
To get to the ashtray bulb on a 1997 Z71, the console top needs to be removed. First remove the ashtray from its holder. Then, remove the clips on the sides holding the console top on.