(B)usiness (T)elephone (S)ystems
i.e. Mitel, Shoretel, NEC, Inter-Tel (now Mitel), Avaya, Lucent, Cisco, Alcatel.. etc etc.
BTS - Base Transceiver Station
600 WATT
48 is volt scale and negative voltage is used for safety of media, to prevent attanuation and noise.
TRX stands for TRANSMIT RECEIVER. TRX has different combination depending on the user requirement. 1 trx has 8 TS out of which one is allocated for BCCH.Rest is used for voice trxmns and for data purpose.
Because 2 terminal comes out from the battery and through red wire we ground the +ive terminal so that possibility of noise interference will get zero....noise occur only in the +ive terminal.....thats why we use -ive voltage.
this would need some more detail , to be specific , and dependant on whether temperature, pressure , level or flow types. .. generally you should consider the impact if the system fails / would it result in a catastrophic situation arising, resulting a dangerous condition .? are there any fail safe emergency arrangements needed to continue cooling via pumps, or safety valves to control a pressure safely. is the new system about to be commissioned the right type for the application ? .. is installation - method the correct one.? are the sample and return pipelines set up correctly ? are there any intrinsic - safety requirements? should a valve stem or piece move during its operation ; will it clear any local objects or strike them resulting in a failure ? . is the electrical system designed suitably for the power consumption ? are there any IP - protection sealing requirements needed ? . if the application involves a flow measuring system ; the isolation -- valves should be commissioned by equalising the pressures across the instrument manifold. then opening slowly theLP low pressure isolator, and then fully, and finally opening the HP isolator to commission the instrument .
Answer'BT'British Telecom (Corporation)Bit Torrent (form of Peer-to-Peer file Sharing)Brian Wayne Transeau (Musician)Bacillus Thuringiensis (natural insecticide)Perhaps if you were a bit clearer on what it is you're asking about,the answer could be more clearly defined. Thank you.
The full form of BTS is "Bangtan Sonyeondan" which translates to "Bulletproof Boy Scouts" in English.
If Your Question is related to Telecom Wireless, this is the Ans: Handover is used to continue the service being used, if a user moves from serving BTS to Target BTS.
full load on one bts site 35 amp.
The function of FXC Card, is to provide E1 conectivity to BTS. It have four E1 port and it can be used to connect other bts as "cascade". Where do you hear about this card? Do you work for a telecom company? Please, let me know in order to help you.
Well, there are lots of meanings for bts. here are some exmpels...: -Burn the stage -behind the senene and more!! Bts is a bangtan k-Pop artist a that is takeing over the world!!
it is a unit in a BTS i.e. base transreciever system..these bts are installed with towers that are used for mobile communication. The piu consists of a power plant and battery bank. power plant has rectifier to convert ac to dc and battery back up is used in case of power failure.
3g BTS is greater than 2g bts. and it is with new technologies.
Indoor BTS: It is placed in a shelter Air-condition is must Very sensitive Outdoor BTS: No shelter required Air-condition is not a must Not very sensitive comparing to indoor bts
GSM900 transmitted power from BTS: 39dBm GSM1800 transmitted power from BTS: 36dBm
typically 2km
FIU use in Bts for large number of channels