Want this question answered?
What is the name of my great uncle?
Bring the piston up on tdc right after the intake valve closes and then loosten the adjusting nut until there is slack in the rocker arm. Tighten it down until the slack is gone,{you can tell by turning the push rod} then turn it 3/4 more. Do this on all cyls.
You have to adjust the rear brakes, after you adjust the rear brakes the slack will almost be gone and you'll find the brake lever will grab almost at once. The cable going to the brake lever can be adjusted with a 10mm socket, but adjust your rear brakes first, the remaining slack then will be taken out by tightening the cable.This adjustment is located under the rubber cover, covering the bottom of the brake lever.
probably the clutch cylinder is gone :(
relays gone in abs module or abs rings in hub worn
Bernard, feeling rather lazy, decided to slack off on his project and just threw something together at the last minute.The rope, being held by two people on either end, had too much slack and was not tight enough to be completely straight.The teacher, acknowledging how Molly had gone to a dance competition the other night until 12:00, gave her some slack and didn't give her homework
Video of Avril Lavigne performing "When You're Gone" can be found on many websites. Among them are YouTube, Viki, KoVideo, MTV, SLack-Time, Dailymotion, and ContactMusic.
Chances are the TCS temprature coolant sensor has gone faulty. This will cause the cooling fan to run witha cold engine
the light comes on when the alternator is bad or your regulator has gone bad. some regulators are built into the computer.
Tell them they need to keep up productivity while you are gone, you expect them to work as hard as if you were there. Remind them you will know if they were slack in their work while you were gone. Offer a bonus for those who were the most productive by the time you return.
screws are located behind heater fins also behind steering wheel cowling
most the time it means you didnt tighten your gas cap properly. if its not that its probably a sensor that has gone bad.