This info can always be found in the Chilton or Haynes manual for that model and year vehicle. Tightening sequences usually start from the middle of the cylinder head, then go out as if going in a circle. Example, the 2 bolts on the middle, then the 2 bolts to the right of them, then the 2 bolts to the left of the center, then the 2 even further to the right, then the 2 even further to the left. Often times this needs to be done in multiple stages, like 30ftLbs on each bolt, then back around again with 60ftLbs. Just an example, check out the manual and it should tell you exactly what you need to know. -Shaun
get specs from your local librarys technical isle look up specs and tightening sequence.
80 nm
There will be a diagram of this in every car's manual. -Follow that specific diagram to order of tightening and torque specs.
Ineed the torque sequence and tightening specs for a 92 GM 3800 intake.
what are the torque specs and sequence for a 1992 Nissan maxima manifold
Go to NAPA and buy a repair manual for your specific car.
The cylinder head bolt torque specs for a Mitsubishi 2.0 or 2.6 is 65 to 72 ft. lbs. cold. Torque sequence is as follows.
what is the engine code??
Head torque sequence for a 2002 3800
I need head bolt torque specs and sequence on 2003 Chevy Malibu 3.1
21ft lbs
torque specs in Nm and tightening esquence