Head light switch 93 topaz?

replace head light switch on 93 ford explorer

Its just a geuss. but on my 93 mercury topaz the head light switch alsoe controls the lights in side the care. If it's clicked all the way on that might be why.

The fuse box for a 93 topaz is located under the dash board on the drivers side just beneath the switch for the headlights (you have to look under the dashboard to find it)

the ash lights come on when you turn your park/ head lights on are so you may have a faulty head light switch!

brake light switch is broken or out of adjustment. brake light switch is located above brake pedal.

The 1993 Mercury Sable backup light relay switch can be found beneath the drivers side dashboard. The backup light relay switch will be above the accelerator pedal.

The head light switch is shorting out ,or a bad connection

The 1993 Jeep grand Cherokee brake light switch simply plugs in and out. The brake light switch is located beneath the dashboard on the drivers side of the engine compartment.

Make sure switch in trunk is in proper position

are you thinking about the dimmer switch or the actual illumination light? on the left side of the steering wheel you will find the dimmer switch, and the dash becomes illuminated from the first click of your headlight switch.

There is a brake light switch or stoplight switch that may be bad on the brake pedal up top.

how do caravanu change ignition switch in 93 dodge

check the switch at the top of the brake peddle.

On my 93 mod. it is between the steering wheel and the dashboard

I would be thinking it is a head gasket.

I have a 93 and my switch is behind the passenger side kick panel.

how to change manual ignition switch on a 93 Honda accord

It is not equipped with an inertia switch.

I am not quite sure what you mean? Why do you need a fuse?

It is part of the Neutral Safety Switch attached to the side of the transmission.

The reverse light switch is located on the drivers side of the transmission, towards the top. I believe on a 93 it will have two wires going to the connector on it. It just snaps on with two prongs. Lift those and remove the attached wire connector. It will pull straight out. The reverse switch is removed easily with a wrench. I just replaced mine, and it cost me around $10

on an 89 It is connected to your pointer for the transmission in the dashboard if that isin't working, maybe the connecting cable came off, then the switch will not be activated

The backup light switch is under the air filter assembly. You'll have to remove the assembly to get at it. There are only two wires on top of the transaxel assembly. One is a very obvious ground wire, the other is the backup light switch. Have fun, you'll need a 10mm wrench and a 12mm wrench for the job.

It is controlled by the ignition key. It has no inertia switch if that is what you are asking about.

it should be located right below the oil filter in the front