How Do I Change the back brakes on Daewoo matiz?

you must be using the brakes too much, start using the handbreak more please.

They make a SPECIAL glue/grease that goes on the back of the pad- NOT THE ROTOR SIDE.also MAKE SURE ALL the ANTI- RATTLE clips are on the pads & the pad Mounts.(end where the pad slides)

In what sequence does it go back

how do i change back brakes on a 1991 toyata corolla

The brakes automatically adjust every time you back up and use the brakes to stop. The automatic adjustment is common in most automobiles.

This answer is in relation to a Matiz on a 51 plate. The surround is removed by unscrewing 4 screws around where the speedo display is situated, and another screw at the back of the compartment below the radio. after this the surround pulls off. To refit, the surround just pushes back on and replace the screws.

I need help on fixing my back brakes on my 1997 sunfire

Take it to a professional

To change the front disc brakes on a Kia Rio, simply remove the assembly held by two bolts. Push the piston back and replace the disc brakes with new.

First of all, Do you have any specialty brake tools? Ben

Remove the back seat and it should be acessible from within the car.

prise lamp cover out by placing a small flat screwdriver in small recess of lense located near the light switch. replace bulb locate the two lense tabs into light unit and press lense back into place. easy job as replaced mine recently

You probably need to change your back brakes.

go to a local garage go to a local garage

Answer Looking at the engine undo the rigth nut on the battery braket till you can slide it over the metal bracket. Undo both Plus and Negitive nuts (warning watch spanner does not connect plus and negitive). Lift battrey out and replace . Connect back up and secure in place . And don't forget to set the time again.

I have a 99 grand am and I am tring to replace the brakes on the front of my car but when I go to put the brakes back on the caliper wont line up wheats wrong with this? How do I fix this?

Yes, you need to seriously change your brakes. You do not have any brake fluid in your car because your need brakes badly. If you don't take the car in and the back brakes are bad, it's going to cost a lot of money to repair them.

It would be helpful if you could tell us the make and year at least. -

use autozone.com or go to autozone and you can get a print out of how to change your back brakes.just make sure you get oem pads or you will have a lot of trouble down the road.

Not really unless all your brake bads are badly worn down , since abs compensates for the rate of rotation for each wheel so that you brake straight , keeping in mind that the front brakes take the most load and the back brakes take less so you should replace them in sets (front brakes) & (back brakes)

how to remove back brakes on a 2002 Chevy surban

The rear brakes are a conventional drum system. If you don't have experience working one them I suggest buying a repair manual or taking it to a shop.

30 psi front and back.

If you mean the back brakes, I have a 1994 Lincoln Continental. To replace the pads on the back, I had to buy a special tool to depress the cylinder. Its a screw type cylinder and had to have this tool to put new pads on.

Remove tires unbolt caliper remove old pads compress piston back into caliper put new pads on put caliper back on put wheels back on