0
Want this question answered?
Be notified when an answer is posted
Add your answer:
Earn +20 pts
Spongy brakes on 1990 ford ranger?
May have air in the system and have to be bled Check the flexible brake lines (front) to make sure they are not ruptured and are ballooning when brakes are applied
Having brake problems on a 95 ford ranger xlt 2.3l v6 you replaced master cylinder brake booster bled the brakes pedal still goes to the floor?
You need to bleed the brakes.
Replaced all brake parts on 94 ford tempo power bled but still no brakes when engine is running?
Did you replace the master. It might be by passing.
What causes ABS brakes to be spongy?
ABS brakes are not spongy. If you have spongy brakes the reason is that there is air in the system. You need to have your brakes bled.
How do you repair a master cylinder on a Ford Taurus?
get a new one then bleed your brakes A new Ford master cylinder must be bench bled before it is installed, or it will be impossible to bleed the system later.
1991 Ford Aerostar both brakelights are on I do not have the owners manual One light is for the rear antilock brakes and the other states brakes I P What do these mean I just bled the brakes?
HI, Question, where the Lights on before you bled the brakes? or did they come on only after you bled the brakes? Please let me know, Ben (Benny the BomB) ________________________________________________________________ on some cars the antilock brakes throw a code so all you haft to do is clear the code.As for the parking brake it may need to be adjusted so just pull on it a couple times. it is self adjusting ou shouldent haft to adjust it were it splits unde the car or something els is seriosly wrong.
When was HDD Bled created?
HDD Bled was created in 2010.
The brake pedal slowly creeps to the floor when you hold the brakes on a 1994 Ford F-350 with a Diesel eng.?
Check your brake fluid. Next maybe your brake lines need to be bled. OR you just might need new brakes.
What if brakes are not building up pressure to stop?
You have air in the lines and they need to be bled out.
Why do the brakes go to the floor before beginning to respond?
you either need a new brake master cylinder or your brakes need to be bled
Why would you hear air when brakes are pressed?
brakes may need bled but more than likely vacuum booster is bad
Why does break peddle go to the floor after they have been bled?
Depends on if all four brakes were bled, if they were look at vacuum leaks or a faulty master cylinder as the culprit
