You can glue toothpicks in layers around the egg then make a container for the egg to go in.Also, you can put super glue around the egg.I think if you did this your egg would withstand the fall.
Make the car out of a frame of popsicle sticks and the egg will not break.
Glue toothpicks side by side Turn it over when its dry and use the bird nest design. You scatter the toothpicks on the deck and add glue on top Wait for it to dry and now you have a strong toothpick bridge.
this is just an opinion but you could loosely wrap the egg in tape to provide a soft outer shell, then make a cube out of many, many toothpicks and glue. next place the tape covered egg in the box and add a lining of straw between the egg and the toothpick box. then close the box and use a little tape around the toothpicks to add more of a stable protective cube. on impact, the cube should break open absorbing allot of the fall. the egg will hopefully bounce around a little. (without the bounce, the egg doesn't move at all] the pressure inside the egg will break it...) i hope this helped... idk, just a dumb idea Okay, good idea, but the we are talking about straws, not straw. The straws, along with the toothpicks and glue could make a substantial tinker toy type protective box. Built into a box consisting of two inch squares, a 20" box would have 10 layers of shock absorption Or, build a round ball with the straws and toothpicks to build a Mar's rover type balloon cushion. Of, course with the egg wrapped and suspended inside with the tape.
not without a permit
Resistors come under passive electronic components and are extensively used in electronic circuits. So important are these components that it may be virtually impossible to build an amplifier circuit without involving resistors. Basically the function of a resistor is always to oppose the flow of current through it and the strength of this opposition is termed as its resistance.
You can build a scale model/toy bridge out of toothpicks. You can not build a real bridge to walk on out of toothpicks.
get lots of toothpicks
Make it with toothpicks.
lots of glue.
curved
Make the car out of a frame of popsicle sticks and the egg will not break.
You can build a model two story house out of toothpicks or ice lollyÊsticks. Build the two stories separately and then attach the upper story to the lower story.
There are many ways to build a suspension bridge. It can be build out of wood, popsicle sticks or toothpicks. However you still need sting to connect the top to the part where the car passes.
Buy pieces of styrofoam. Then, you stick the base in styrofoam. Next, you measure the length of the first piece and the length of the shape of the toothpicks. You may put some vertical on the horizontal toothpicks. Cut off the top of the toothpicks, and put glue on them. If you just poke the next piece of the styrofoam on, you wouldn't be using the glue. Make sure the length of the styrofoam is slightly bigger than the shape of the toothpicks. Glue the styrofoam on. Lastly, do it over and over again until reached height desired. You will need • pieces of styrofoam • Over 100 pieces of toothpicks • Elmer's Glue-All glue
Obviously a ground breaking ceremony is a ceremony involving the "breaking of ground". In other words when you begin to build a building you have a ground breaking ceremony. Officials typically plunge shovels into the ground and lift shovel-fulls of earth to symbolize the beginning of construction, even though no actual work is done that day.
Glue toothpicks side by side Turn it over when its dry and use the bird nest design. You scatter the toothpicks on the deck and add glue on top Wait for it to dry and now you have a strong toothpick bridge.
Yes, with a lot of tooth picks and a few bottles of glue you can make fences out of toothpicks. However, you may want to build a little house to put your fences around so they won't just be random fences.