0
Want this question answered?
Be notified when an answer is posted
Add your answer:
Earn +20 pts
Cause of pto clutch staying on a Honda mower?
pto switch bad
Why would a Briggs and stratton lawn mower engine stall when the pto is engaged?
Typically this is caused by a bad seat safety switch.
What is a manual pto on a john deere d 130?
The manual pto is the switch used to engage the mower deck.
How do you engage the blades on cub cadet 3184?
pto switch energizes a vacuum solenoid which puts pressure on the pto belts
Why won't John Deere lawn tractor PTO switch not engage for cutting?
Could be the pto/drive shaft not connected or engaging, or the belt could be off. Pivot the wheels sideways, drop and remove the deck and remove the cover panels to replace the belt. Belt is on, but, PTO drive does not engage (does not turn-on).
How do you engage the cutting blade on a john deere 165 hydro riding mower?
There's a yellow switch in the upper right hand portion of the dash. It's the PTO drive. Engage your clutch, pull up on the switch and move it forward, and that should start the blades spinning. If it fails to engage, it could be a bad switch or a bad battery.
Where is the safety switch on a Kubota F3560?
There are many. PTO. Seat. HYD drive peddle. Neutral.
John Deere Lawn Mower Model 188 blows fuses when clutch is engaged?
This is most likely a blade clutch problem. Many times they short and have to be replaced.
Why won't Craftsman lawn tractor blades engage?
Your switch may be bad or came disconnected. Or your PTO could have came unplugged, or it went bad.
How do you engage the pto on 2010 jd?
To engage the power take-off (PTO) on a 2010 John Deere tractor, typically you would push in the PTO switch or lever located on the dashboard or control panel. Make sure the PTO is properly connected to the implement before engaging it to prevent any damage. Always refer to the operator's manual for specific instructions related to your tractor model.
What is PtO-H2O?
PtO+H2O
Why does your John Deere mower die after engaging the blades seat safety switch is by-passed?
I believe you have a defective seat switch. The switch is designed to sense if the operator is setting on the tractor when the PTO is engaged. For instance, if you stop moving and step off the tractor with the PTO engaged, it will kill the engine for safety reasons. When the switch is defective or has a disconnected/broken wire, the switch will not send a signal that there is a person on the seat. The switch is located either on the tractors seat pan under the seat or may be located in the seat itself. It is easy to test the switch with an ohm meter, if the switch tests good, work your way back the wires until termination to look for failures. If you are a person of light weight, the switch can be adjusted for sensitivity by loosening the lock nut and raising the switch higher on the seat pan or further into the seat. Other things to check; 1. while setting on the seat with the key on but not running, you may hear a click when you turn the PTO switch on. 2. If the above is true, remove the spark plug wire(s) and attempt to turn the blades by hand, they should move freely. 3. If the above is not true, something is binding the deck/blades which will cause the engine to die. 4. Remove the belt the goes from the PTO to the deck and try turning on the PTO as normal, if the engine dies, it is likely the seat switch. If not, it is likely that the deck is the cause. Hope this helps.
