0
John Deere Lawn Mower Model 188 blows fuses when clutch is engaged?
Wiki User
∙ 13y ago
This is most likely a blade clutch problem. Many times they short and have to be replaced.
Wiki User
∙ 14y ago
Wiki User
∙ 14y agoi would start by replacing fuse disconnect pto clutch,turn ignition switch on engage pto switch if fuse doese not blow, the problem is in the pto clutch or re-set air gap in the clutch
Wiki User
∙ 13y agoCheck your clutch switch it may have shorted out to the frame.
Wiki User
∙ 14y agok whats wrong with it.
Add your answer:
Earn +20 pts
How do you fix clutch on riding lawn mower?
clutch for (your model mower) on eBay or other site that sells mower parts
How does the blade clutch work on John Deere JX75 mower work?
When the bail for the the blade clutch is pulled back, against the force of the return spring, the blade is engaged with the engine crankshaft allowing it to spin. When the bail is released, the spring snaps back and the clutch disengages the blade from the crankshaft and stops the blade.
What year is John Deere ride on mower model LX277?
1998
John deere 318 engine stops mower stops engine will restart but mower deck will not too hot?
Your mower has an electric PTO clutch that is worn out. It clutch stops working when it gets hot. Replace the PTO clutch and you should be fine. Expect to pay about $150 for the part.
WhatSpark plug for John Deere mower model 14sz?
Champion RJ19LM
How fast does a john deere riding lawn mower model gt262 go?
6mph
Why won't engine start after engine stopped with blades engaged this is a john deere riding mower.?
Turn your blades off.
I need a mower belt diagram for a John Deere 110?
The John Deere LA130 is a model of riding lawnmower produced by the John Deere Company. The mower uses a 48 inch mower belt. Replacement mower belts are available online and at specific retailers.
When you start your john deere lawn mower it runs but when the clutch is engaged it dies?
Check and see if somthing is stuck in the pullys.If not check pully see if you have any bad bearings on them.Could be a bad safety switch.If not transmition or rear end problem.
John deere stx30 mower?
when I try to engage gears of mower blades, the engine dies under the load. Read wheels also lock when fowrad and rear gears are engaged.
What is the smallest John Deere riding mower?
john deere smallest riding lawn mower
When i start my craftsman lawn mower it runs time but when the clutch is engaged it dies.?
Your clutch has to be engaged when you start your mower or at least my craftsman mower does. If it dies when you release the clutch pedal, it is due to the engine shutoff relay which is wired to the electric clutch. There are 2 wires on the lower left side of the mower that run along the inside of the frame to the clutch. These wires run just above the mower deck belts and connect to the top of clutch. They are so close that sometimes they get entangled with the deck belts causing them to be torn loose or rub the insulation off and expose the bare wire (which will cause it to ground out if it comes in contact with metal). You need to find and inspect these two wires all the way from the clutch to the point they come up through a hole in the frame floor that the engine is bolted to.
