Your clutch has to be engaged when you start your mower or at least my craftsman mower does. If it dies when you release the clutch pedal, it is due to the engine shutoff relay which is wired to the electric clutch. There are 2 wires on the lower left side of the mower that run along the inside of the frame to the clutch. These wires run just above the mower deck belts and connect to the top of clutch. They are so close that sometimes they get entangled with the deck belts causing them to be torn loose or rub the insulation off and expose the bare wire (which will cause it to ground out if it comes in contact with metal). You need to find and inspect these two wires all the way from the clutch to the point they come up through a hole in the frame floor that the engine is bolted to.
sears
Check your fire and gas.
The safety switch to start the motor on a Ranchking riding mower is located in the ignition. If the clutch needs to be depressed several times before the mower will start, there might be a problem with the adjustment of the clutch.
Where are the grease fittings on a 18.0 hp, 42" craftsman mower electric start 6 speed translate transaxle
Nope, i can start my 720 without clutch engaged. Its a 1984 720 with the z24 motor if you were wondering
Spray some ether in the carb. If it fires, it has spark, but not getting fuel. start there.
to start with when you push in on the clutch pedal you are disengaging it. Your description sounds like the clutch has clutched its last clutch What if it is not the clutch?
Clean/replace spark plug and air filter. If problem persists, open needle valve 1/8 of a turn for a slighlty richer mixture, Something else to check. Some riding mowers have a sensor switch that will not allow the blades to engage unless the clutch is depressed. The switch may be faulty. Not sure exactly where it is located, but since it is activated by the clutch pedal, I figure that is the place to start.
20-22 ich cut...... 20 fl oz max
sounds like the clutch switch neeeds replacing or cleaning.
gas settled in it & its dirty.
With the ac off your clutch the outer non belt driven part will not be turning. When it is turned on it will start to spin.