0
How can you change a timing or a drive belt on a 2002 Chevy Tracker with ac?
Wiki User
∙ 16y ago
Loosen the fan belt and take it off. Then with a long half inch drive socket wrench or torque wrench, let the tension off of the accessory belt and remove it. Make a diagram of how it is installed before removing it for easier installation. Took me all of a few minutes once I figured out which bolts to loosen to get the fan belt off. Putting the accessory belt had me scratching my head for a moment until I finally figured out how it went back on. I forgot the make a diagram first! This was a four cylinder engine by the way.
Wiki User
∙ 16y ago
Add your answer:
Earn +20 pts
How do you change the timing belt on a 1982 Chevy caprice 305 v8?
There is no timing belt on a 305 unless it is an aftermarket belt drive system.
When to change the timing belt on a 2000 Chevy prism?
between 80 and 100.000 km drive safe
What type of oil does a 2002 Chevy tracker take for the 4 wheel drive?
5w30
Does a 2003 Chevy truck s10 V6 4wheel drive 4door have a timing chain or timing belt?
Timing chain NO belt.
When to use over drive on Chevy tracker?
When you're cruising along at highway speeds on level roads.
How often do you need to change a timing belt on a 99 Chevy Metro?
every 100K miles, unless you drive it really hard ... if so, replace it sooner
How do you replace the rear engine main seal in a 1999 Chevy Tracker 4 wheel drive?
Pull the engine.
Is there an electronic heater control valve on a 2002 Chevy Tracker?
when you put drive chevy blazer 2002 ls 4wd it turns off, what's the problem
What are the timing specs for 92 Chevy Caprice?
0 degrees in drive bypass disconnected
Can the front hub assembly on a 98 Chevy tracker 4wheel drive be replaced with a 98 sidekick 4 wheel drive front hub assembly?
yes
How do i change the bearing on a 1996geo tracker front of a 4 wheel drive?
how do I get to the front bearing on a geo 4 wheel drive
How do you change gear drive in on Chevy Celebrity 1987?
you would need to change the differential gears to change the gear drive.
