Configure the mobile device to use airplane mode, tap the settings app and turn Airplane Mode on which disables all antennas so the device can neither transmit nor receive signals.
A modem allows your computer to connect to a phone line.
h-parameter used to find the input and output impedence of the two port network. suppose if u connect a high load at the output port then u should take care that no current from the device will attack the network, to determine that we should know what is the impedance of the circuit.
It is the terminal on the megger that the ground cable connect to when testing a device to ground.
service set identifier, a 32-character unique identifier attached to theheader of packets sent over a WLAN that acts as a password when a mobiledevice tries to connect to the BSS. The SSID differentiates one WLAN from another, so all access points and all devices attempting to connect to a specific WLAN must use the same SSID. A device will not be permitted to join the BSS unless it can provide the unique SSID. Because an SSID can be sniffed inplain text from a packet it does not supply any security to the network. An SSID is also referred to as a network name because essentially it is a name that identifies a wireless network.
As transformers do not work with DC., the answer is a voltage divider network (step down) or a voltage multiplier network (step up).
We know that a router is a layer 3 device means Network Layer. Router is a only device that can forward only uni cast massage. If u configure the router well and connect the two separate network, i think the network will go finely.
node
A network ready device is a device that has the potential to connect to a network, natively it isn't connected to a network, nor is it a network, but with the appropriate configuration and possibly with the addition of components could be connected.
NIC (Network Interface Card)
valid IB
You can connect your device to internet network wirelessly.
a modem
Switch
To connect to a cisco 1800 series router, you need either a network connection that goes to the router, and then you would configure the router to allow telnet or you would need a console cable, also called a rollover or cisco cable and physical access to the device.
A mobile phone.
a modem
One device that is shared on the network is a router. This is the one that will connect the various devices to the shared network.