With a inverter fed drive (frequency inverter), you can increase nominal rpm of a induction motor, but may be the iron core drop in saturation mode and mechanical damage can run because the motor have specifically mechanical design. I think that some up, like 10% (if 50 Hz nominal, then 55 Hz operation) is possible without risk.
Remember: Induction motor runs some down of synchronous speed Ns, and Ns=120*f/p where p is the number of poles (if motor runs near of 1800 rpm, it may has 4 poles and is based on physical construction of motor) and f the frequency. Then, only f may be adjusted to obtain velocity variation.
Bye!
JACk
Why is RPM (speed) so important to the life of a compressor
Normally, there is only one compressor in each refrigerator. The compressor helps in cooling the inside cabins of the refrigerator.
Depending on the refrigerator, it's TYPICALLY a "rotary vane" compressor, but that's not always the case.
the compressor is coupled with engine.when the engine runs at 1000 rpm ,the compressor also will work at that rpm ,so that is air is compressed in tanks and it is used for applying.
No
The compressor is the part of a household refrigerator that cools the air. The function is absorption but the compressor creates the absorption.
trash it
yes.
No
It makes noise and cools everything.
it is necessary to heat the compressor and strike it with a rubber mallet!
Your RPM's increase automatically to compensate for the additional load from the A/C. As the A/C compressor runs in defrost mode to prevent fogging, the same will happen there. It's just your electronic engine controls maintaining the correct idle RPM.